SOURCE: Chevy Uplander LS 2006
Go to your local salvage yard. We bought LS seats to replace on our LT model. I liked the intergrated child seat and it only came in the LS model. The dealer charged almost 500 a seat. I found out later, salvage yards have many parts that are brand new and half the amount. The seat could have cost us $350 for both! Some yards will search for you. Good Luck!
SOURCE: 98 chevy malibu:engine wont turn
Check with a battery tester if you have power at the starter, Are the Battery post clean, Are any fuses blown in the fuse Box, check for any corrision.
SOURCE: 1999 chevy malibu LS
If the check engine light is on, I would take the car to an autoparts store and have them scan the computer for fault codes. Most parts stores will do the scan for free. It sounds like it could be a faulty idle air control valve, but getting the codes should end speculation and identify the faults that the computer has noted. Hope this helped and best wishes.
Testimonial: "thanks"
SOURCE: Where does the flasher go on a 98 chevy malibu
Replacement
The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
Remove the bezel from the ignition switch
Carefully remove the instrument panel accessory trim plate.
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .
. . . then gently pull the accessory trim plate away
Detach the electrical connector from the hazard warning switch.
Unplug the electrical connector from the hazard warning switch . . .
Unfasten the screw securing the hazard warning switch and remove the switch.
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle
Installation is the reverse of removal.
Testimonial: "just what I needed, thank you so much."
SOURCE: how do i repare a 98 chevy malibu ls abs sensor
There is no "repairing" sensors, they must be replaced. Maybe built into the wheel bearing
Ignition Switch Will Not Turn Off?
http://schematicsdiagram.blogspot.in/2012/04/ignition-switch-will-not-turn-off.html
----------------
1995 Ford Taurus: Ignition switch not turning OFF?
http://repairhelpcenter.blogspot.in/2012/06/1995-ford-taurus-ignition-switch-not.html
-------------
Ignition Problem Troubleshooting
http://whoisbyme.blogspot.in/2012/07/ignition-problem-troubleshooting.html
------------------
These
will help.
Thanks.
337 views
Usually answered in minutes!
×