I have a left front clearance light out how do you get it out 1

Fig. 4: With the bolts removed the lens may be separated from the bumper






Front Marker Lights
On most vehicles covered by this manual, the front marker lights are mounted in a lens attached to the headlight bezel (pre-1990) or the one piece headlight bezel/grille assembly (1990 and later vehicles). Replacement usually requires removal of the bezel or bezel/grille assembly for access to the bulb twist socket.







Fig. 5: Exploded view of a common front marker light lens mounting

Disconnect the negative battery cable.

If equipped with a separate headlight bezel, remove the headlight bezel-to-fender screws and the bezel; allow the bezel to hang by the turn signal/marker light wires.

If equipped with a 1-piece bezel/grille assembly, remove the grille assembly and support it on the bumper as you work.

At the rear of the bezel mounted lens, turn the marker bulb socket 1⁄4 turn and remove it from the headlight bezel.

Remove the bulb from the turn signal/marker bulb socket; if necessary, replace the bulb.

To install, use a new bulb (if necessary) and reverse the removal procedures. Check the turn signal/marker light operations

Fig. 6: Remove the marker light twist socket from the back of the lens










Fig. 7: If replacement is necessary, remove the bulb from the socket



Fig. 4: With the bolts removed the lens may be separated from the bumper


Front Marker Lights On most vehicles covered by this manual, the front marker lights are mounted in a lens attached to the headlight bezel (pre-1990) or the one piece headlight bezel/grille assembly (1990 and later vehicles). Replacement usually requires removal of the bezel or bezel/grille assembly for access to the bulb twist socket.

Fig. 5: Exploded view of a common front marker light lens mounting



Disconnect the negative battery cable.
If equipped with a separate headlight bezel, remove the headlight bezel-to-fender screws and the bezel; allow the bezel to hang by the turn signal/marker light wires.
If equipped with a 1-piece bezel/grille assembly, remove the grille assembly and support it on the bumper as you work.
At the rear of the bezel mounted lens, turn the marker bulb socket 1⁄4 turn and remove it from the headlight bezel.
Remove the bulb from the turn signal/marker bulb socket; if necessary, replace the bulb.
To install, use a new bulb (if necessary) and reverse the removal procedures. Check the turn signal/marker light operations
Fig. 6: Remove the marker light twist socket from the back of the lens


Fig. 7: If replacement is necessary, remove the bulb from the socket