How to remove the tranfer caes on a 2005 endeavor v6 3.8l

Hi Evelyn.here's a link on your oil pan removal,it says engine removal,will send a link on that too. SAVE 20 ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE Here's the engine removal guide. SAVE 20 ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE

remove the bracket as well i think 3 bolts.

remove tire. remove axle locknut in the center of spindle. remove lower ball joint . swing the spindle out of the way and separate the axle from the spindle. pull axle out of transmission

jack the car up then you should ne able to remove the tire

You planning on installing a salvage yard unit

That is just someone elses junk

Repair Yours or trade it in for a Jasper
Engine & Trans rebuilt

The fuel pump will belocated within the gas tank. Typically on SUVs ther will be an access to the tank under the rear carpet. Remove the required trim pieces and carefully pull back the carpet to expose the access cover plate, remove it (typicall 6, 12MM bolts or so) and you'll then have access to the top of the tank and its components.

I hope this may have assisted you,
Tom

puede ser tu heater core que esta danado no tapado ,necesitaras que reemplazar la unidad ,las salidas del agua deben de estar en el moitor del lado del pasagero son mangueras de hule pero casi nunca se tapan ,mas informacion dejame saber gracias.

Is there a reason you took off the battery cable ? You probably blew the fuse. Check fuses under hood and inside the cae.

THEIR ARE ABOUT 9 BOLT TO REMOVE THAT SUPPORT THE INTAKE. 2 ARE IN THE REAR IN THE CENTER OF THE SUPPORT BRACKET THE 5 THAT ANCHOR THE INTAKE ITSELF AND 2 UNDER THE INTAKE THROTTLE BODY. ( 12MM) 3 HOSES ON TOP OF THE INTAKE TO REMOVE AND 1 SENSOR TO UNPLUG OR UNBOLT (8MM)THE ONE ON TOP OF THE INTAKE (TOP LEFT REAR). THIS WILL GIVE YOU ACCESS TO THE REAR PLUGS.
REMOVE THE SENSORS BRACKET OR HOLDER ( ON THE LEFT JUST LIFT UP TO REMOVE) AND SWING THE INTAKE TO THE RIGHT. UNPLUG THE PLUG MODULE THEN UNBOLT THEM (10MM).

Remove Endeavor Rear Panel

On the side panel there is a cargo hook with a 10mm bolt. Take that bolt out. On the floor panel there are 2 cargo hooks -- also 10mm. Take them out and remove floor panel. Fold seat forward and you should have access to 5 or 6 bolts -- also 10mm. Remove them then pull the panel out slightly and disconnect the cig ligthter and that should solve your issue.