SOURCE: I have 2003 gmc envoy my front ac control does not
Need to check to see if the blower motor is running.If it is,but not threw the vents,most likely a vent door actuator motor.The actuator motor in this case would be bad,it is hard to get to,unless you are mechanically inclined,You can do it your self.If the blower motor is bad,just replace it.Check fuses first,and the blower relay.If I can help,let me know.
SOURCE: 2002 gmc envoy xl front wheel bearing assy replace
take the wheel off,take the axle nut off,disconnect the spindle from the ball joint or joints, take the tie rod end out of the spindle and remove the spindle leaving the axle in the transmission. Now there is three bolts on the back of the spindle take theese out and beat the hub and bearing assy out. The new one wont be as hard to put in as the old one was to come out.
SOURCE: How do you remove the starter off a 2005 GMC Envoy
1st, remove the positive lead to the abttery. Next disconnect the wires from the starter one at a time. I recomment you wrap each with a layer of black electrical tape to protect them. After the wring is removed, remove the bolts to any brackets that are attached to the starter and the two large bolts holding the starter into the transmission housing. Remove the starter. Reverse order to install new starter. Test before your close the hood. It isn't very difficult. If you run into problems, ask me, and I will assist you.
SOURCE: how do you replace tailgate struts on a gmc 2006
There should just be metal clips on each end. Use a thin/standard screwdriver and pry out on the clips. They won't come off completey, but just pop out a little ways. Once they do, just pull and wiggle the strut and it should pop off the ball it's snapped on to. To install the new ones, just make sure the new clips are in the "out" position, snap the socket on to the ball and push in on the clip to secure it in place. Hope this helps.
SOURCE: 2005 GMC Envoy XL High Speed Blower not working
if the other speeds work it is probably the blower resistor; if applies varying resistance to the voltage running the blower; this allows the fan to run at different speeds; should be located very close to the blower motor; behind a panel under the passenger side of the dash
76 views
Usually answered in minutes!
×