SOURCE: 2002 audi a4 quattro 3.0 serpentine belt diagram
Hello m_hueffer, my name is JShreader. Thank you for choosing fixya.com.
Here is the diagram you requested...
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!
SOURCE: i want a user manaul for my audi a4 1.8l quattro
Here is a manual, but you have to purchase it:
http://shopping.msn.com/prices/audi-a4-service-manual-1-8l-turbo-2-8l-including-avant-and-quattro/itemid2373553/?itemtext=itemname:audi-a4-service-manual-1-8l-turbo-2-8l-including-avant-and-quattro
SOURCE: 2001 audi a4
Transmision oil for 2001 Audi A4 1.8 l turbo:
Manual gearbox (5 speed):
- Capacity = 2,25 liters
- Specification: Gear oil SAE 75 W 90 (synthetic oil)
Part number G 052 145 S2 (1 liter)
- To check oil level, unscrew oil filler plug placed on the left side of the gearbox in front and near of transmission axle, using an Allen 17 mm key.
- Check oil level with locally manufactured tool, e.g. a piece of angled wire.
- Specification: oil level 7 mm below bottom edge of oil filler hole.
- Install oil filler plug, tightening torque = 25 Nm.
Please Rate my Response! Thanks!
Testimonial: "thank you.The problem it is done."
SOURCE: serpentine belt diagram for 1996 audi a4 quattro
Ribbed Belt: Service and Repair
Ribbed Belt, Removing and Installing
Ribbed belt, removing and installing
CAUTION: Mark the direction of belt travel before removing, using a crayon or marker. Reinstalling a used belt in the opposite direction
could damage the belt
Note: There are two different types of ribbed belt, identified as versions A and B.
Ribbed belt versions, identifying, refer to Application and ID
Removing
Old version A
- Remove ribbed belt guard.
- Loosen ribbed belt tensioner using 15 mm wrench and drift 3204.
- Remove ribbed belt.
New version B
- Using 10 mm hex socket wrench, turn downward in direction of arrow to loosen ribbed belt.
Installing
Install in reverse order of removal, noting the following:
- Place ribbed belt over drive pulleys and idler roller first, and onto tensioning roller last.
- Remove drift 3204.
- Install ribbed belt guard.
SOURCE: serp.belt route diagram for 98 audi a4 quattro 2.8
The serpentine belt routing diagram for 1998 Audi A4 Quattro 2.8 liters V6 engine:
CS = Crankshaft
F = Fan pulley
Gen = Alternator
T = Tensioner pulley
AC = Air Conditioning
PAS = Power Assisted Steering
335 views
Usually answered in minutes!
×