- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Door panels take a special tool that you can get at an autoparts store. The arm rest has a hidden set of one or more screws in it. Look for plugs in the bottom and sides of it.
Sometimes the lid get twisted. You can open the lid and with one arm pull down on the side that is up and using the other arm push up, twisting the lid a little. That should level it. There are also rubber stops that turn up and down that help adjust it. But I would try twisting it first since thats how it got missed aligned.
Most often this is due to a loose armrest mounting bolt or worn limit washer, unzip the cover and tighten the arm rest first, it is most likely a T45 Torx female bolt head AKA star drive.
This is not a bad job, just a bit fiddly. You need to remove that central wiper and all the plastic pieces in the area. Get your self a box for the clips and make sure you keep your car keys in your pocket as the mechanism for the wiper motor/linkages can take your hand off in a split second if you have left it on intermittent or somebody switches it by accident.
Take the cap off the large central wiper and index mark the wiper shaft to the arm so you can refit it in the same place. Remove the rubber that goes around the bulkhead sealing off the engine bay. Then just carefully remove the screws and clips and lift off the scuttle panel. The rest if obvious and refitting is a reverse of the above.
hello,first, try to remove the plastic cover in lower part of your console,then remove screw (lower part)in arm rest box,take off the box,try to remove panel with window switch,ty
lift the wiper arm all the way up and out from the windshiled. hold the arm so it doesnt slam back down and crack the glass. rotate/spin the whole wiper blade 90 degrees, counter clockwise, and then pull the blade straight back off the wiper arm. install the new one in the opposite order
×