SOURCE: 98 Nissan Pathfinder Brakelight switch locaiton
Look up arm of brake pedal for a switch that gets depressed when pedal is pushed. Probably near top.
SOURCE: I cant find the engine number for my 98 nissan pathfinder???
Are you looking for a serial number of a model number? The 1998 pathfinders have the VG33E engine (introduced in 1996)
SOURCE: where is the fuel cutoff
Reseting the fuel pump kill switch.
Before you reset the fuel pump, make sure to read all of the following instructions!!!!!
1.) Look for an access panel in the trunk, driver's side; it might even be labeled "Fuel Pump Reset".
2.) Open the compartment and press the red button. This should reset the pump.
3.) At this point it might be a good idea to "burp" the fuel tank. This will probably be the easiest thing you do all day! Just pop the cover and unscrew the gas cap, this will release any preasure built up inside the tank. As long as you're in a controled environment, go ahead and leave the cap open until you finish "Step 4". Otherwise "burp" it a couple of times while you're priming the lines.
4.) The next step is to prime the pump. In other words, make sure there is enough gas in the fuel lines to start the car. The easiest way to do this is by turning the key back and forth from the "OFF" to the "ON" position. *** Be sure not to turn all the way to the "START" position until you have performed "Step 4", at least 3 or 4 times. If you attempt to start the car before the fuel pump is properly primed, you will run a serious risk of burning out the pump. This could lead to even more costly repairs!!!
5.) Replace the gas cap before attempting ignition.
6.) Once you have reset the pump, burped the tank, primed the fuel lines, and replaced the gas cap; you should be all set! Go ahead and give it a crank, good luck!!!!!!!!!!!!!!!!
1,394 views
Usually answered in minutes!
×