How to disable anti theft on 2006 Pontiac torrent

Question edited for clarity and English.

Reset the anti-theft system because you disconnected the battery.

https://www.google.com/search?q=2009+suzuki+xl7+reset+security+system

..

2008 Pontiac Torrent anti theft reset
30-minute Learn Procedure

1. Turn ON the ignition, with the engine OFF.
2. Attempt to start the engine, then release the key to ON. The vehicle will not start.
3. Observe the SECURITY telltale. ...
4. Turn OFF the ignition, and wait 5 seconds .
5. Repeat steps 1-4 two more times for a total of 3 cycles/30 minutes . ...
6. Start the engine.

Jun. 16, 2011

My o6 pontiac Torrent has a lock lite on dash and ignition will ...

https://www.justanswer.com > ... > Pontiac Problems Search for: 2008 Pontiac Torrent anti theft reset

It is the passlock system not safelock An you can't just disable it . It is software program into the BCM - body control module an the PCM - powertrain control module .Simply disconnecting the wires from the ignition to the BCM will render your vehicle useless . If an when the security symbol light is on you need to have it checked for DTC'S - diagnostic trouble codes . A GM dealer ,Chevy , Buick , Cadillac etc.... we know Pontiac is no longer around. Everything will work except the PCM will not let the fuel injectors work .
Passlock?"¢ System
The theft deterrent system has been incorporated into the body control module (BCM). The theft deterrent system is provided in order to prevent the vehicle operation if the correct key is not used in order to start the vehicle. The ignition key allows the lock cylinder to rotate. The cylinder rotation produces an analog voltage code in the Passlock?"¢ sensor. This voltage code is received by the BCM. The BCM compares the voltage code to the previously learned voltage code. If the codes match, a serial data message is sent from the BCM to the powertrain control module (PCM). The message enables the fuel injector operation.
The design of the Passlock?"¢ system is to prevent vehicle theft by disabling the engine unless the ignition lock cylinder rotates properly by engaging the correct ignition key. The system is similar in concept to the Passkey system. However, the Passlock?"¢ system eliminates the need for any key mounted components. The components of the Passlock?"¢ system are as follows:
?€¢
The ignition lock cylinder

?€¢
The ignition switch

?€¢
The Passlock?"¢ sensor

?€¢
The BCM

?€¢
The security indicator

?€¢
The PCM

Changing the ignition has interrupted the passlock antitheft system. Here is a link that has some good info on it.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Try checking the oil, the low oil sensor will disable the ignition

occasionaly my car still does not start. Not start how ? When you turn the key in the ignition to the start position , what happens ? Does the engine spin an not start or nothing happens ? Some anti-theft systems disable the starter an some disable the fuel injectors .But no matter which the security light will lit on the instrument cluster. Plus codes would be stored .

turn key to start, let stall and leave key on for 10 min
theft light will go out
do not shut off key and start car

Replace ignition lock cylinder and chip key. The wires have broken.

take the positive side of the battery off for about 3 seconds and then put it back on to see if this will reset the security code

on the ignition key you have to change the ignition baril put new one in try to start it wont leave the key on theft light will flash for 20 minute turn key off and start it thanks pierre