SOURCE: mazda b2000 clutch slips when warm
If you replaced clutch and pressure plate. Did you reverse bleed the clutch cylinder on the firewall? It has air in the system, that is why it is acting this away.
SOURCE: We have an '01 Mazda
When it starts to slip again open up the bleeder screw on the clutch slave cylinder. If the slipping stops then the problem is with the clutch master cylinder. The fluid is not able to return to the reservoir as it expands with heat and is keeping pressure on the clutch. Replacement of the master cylinder would be the best option but first clean out the master cylinder and ensure that the fluid supply hole between the reservoir and cylinder is clear. Renew the piston and rubbers. Check for scoring in the cylinder bore and replace the whole cylinder if scoring is found. If a good cleaning of the master cylinder does not cure the problem a quick-fix on a shoestring budget repair is to fit spacer washers between the firewall and master cylinder or filing down the actuating rod to shorten its length by about 1mm although this is not recommended.
The only other problem I can imagine is that the clutch lever in the transmission is sticking on the guide, although this is highly unlikely.
SOURCE: 92 NISSAN MAXIMA SE . CLUTCH SLIPS WHEN CAR GET
either the clutch operating arm has no free play so its over adjusted which is my first suspect ,or the clutch itself is no good and the spring is weak ,now was this a new clutch from a motor factor or a scrapyard job
SOURCE: Clutch slipping 2002 mazda Millenia automatic
Signs of a new clutch needed, Do you ride the clutch when you drive?
58 views
Usually answered in minutes!
×