SOURCE: 1993 Dodge Dakota tail lights dead
dose it have a trailer package? If so check the plugs that go to the trailer plug that was the problem for my truck to goog luck.
SOURCE: Location of EGR Valve
Found the info!!
This Dodge EGR valve is a certain kind of device that is mounted right on your intake manifold which controls the amount of exhaust gasses back into your engine.
On a 2005 Dakota with 4.7 liter engine (non-HO), the EGR valve is located near the intake manifold on the driver's side right up against the firewall. It's hard to spot as it sits lower than the intake manifold.
To change it, remove the electrical connector. There's a red tab that needs to be pushed to one side and then you have to squeeze down on a tab to get it free. Using a 13 mm socket, remove the bolt that you can see. I had to use a 3 inch wobble extention and then a 8 inch extension with a deep well socket to reach it with my 3/8 inch ratchet.
There's a second bolt that you can't see between the EGR valve and the firewall. With a little trial and error and a lot more luck, you can reach the hidden bolt with the 3 inch wobble extension and a 13 mm deep well socket. Attach the ratchet after the socket is on and remove. This one isn't easy and if there's any Dodge engineers reading this one, a couple of extra inches of clearance between the valve and the firewall wouldn't have killed you no matter what the cost accountants said.
With both bolts removed, you should be able to pull out the metal pipe that connects the manifold to the EGR valve out of the manifold (Pull to the right) and then you can lift the valve out.
For assembly, the metal pipe connecting the intake manifold the EGR valve has to be removed and reinstalled on the new valve. It's held on with 2 5/16th" bolts. You should put the rear bolt on tight, but leave the front bold loose for the reinstall as some adjustment is necessary to get it put back together and the rear is a pain to tighten when installed.
Line up the bolts that attach the valve and get the rear 13 mm bolt (The one you couldn't see on disassembly) started. Do not start the other 13 mm bolt as you'll need to pivot the valve and pipe to the left in order to reinsert the pipe into the intake manifold. Once the pipe is in the intake manifold. Start the other 13 mm bolt and tighten both 13 mm bolts and then the 5/16" bolts holding the pipe onto the valve. Reinstall the electrical connection.
Please don't forget to rate!!!!
SOURCE: Headlights sometimes cut out on a 1993 Dodge Dakota pickup
you may have a bad ground wire up by the head lights the ground spot should be with in a foot of one or the head ligghts
SOURCE: 2004 Dodge Dakota Heater fan motor will not run on low speed. All
Your blower resistor may be wearing out or corrosion setting in. The part is cheap and you can probably replace it. This link shows where an 01 is located. Yours may be in the same spot on on the engine bay side of the passenger firewall. Check with your auto parts store also for location.
http:/www.gtrippleb.com/auto/durango/tech/durango_blower_resistor.htm
SOURCE: Windshield wipers don't work but the motor runs . 93 Dodge Dakota
remove wiper arms and then you can raise the hood to remove screws that hold down the vent panel.
now carefully remove vent panel.
128 views
Usually answered in minutes!
×