Question about 2006 Chrysler Town & Country

Open Question

Where is my PCM located at on my 2006 Town & Country

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 702 Answers

SOURCE: 2006 chrysler town & country 3.8

Check under the panel where the wiper arms are, between the hood and the windshield. Unbolt/screw it and it should be on the pass. side.

Posted on Aug 10, 2008

Ad
short shadey

jeff r

  • 421 Answers

SOURCE: location of the speed sensor on 1996 town & country

they are on the front drivers side of the transmisson and have two wires coming off them, there are two one is an input shaft sensor and the other is an output shaft sensor unless you have a 4 cyl van then there is only one sensor please rate -jeff

Posted on Sep 04, 2008

Anonymous

  • 1392 Answers

SOURCE: Whirring sound after long drives 2006 Chrysler Town & Country

It is your power steering pump. The solution is to replace the P/S fluid resevoir and fill or flush the system.

Posted on Mar 08, 2009

emissionwiz

Marvin

  • 85219 Answers

SOURCE: where is the body control module located on a 1997 town & country

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket

Posted on Mar 23, 2009

Anonymous

  • 85 Answers

SOURCE: Map light replacement on 2006 Town and Country?

Jun 17, 2009- ok I just looked at it. it is simple.
the lens pivots and presses a switch in on one end to make the light come on. take a butter knife or very small screw driver and reach in between the lens and the black center console. there you will CAREFULLY press a flat tab to the side that is made onto the lens ( I hope you dont break this tab).
on the very opposite position on the clear lens towards the door is where the lens has a tab that has a small hole in it. there is a plastic pin made onto the console trim that fits into this hole so the lens will pivot. this will give you an idea of which direction to pull the lens when you press in the tab,. it does look like it would break easily. I havent had to take mine off yet thankfully.
please visit again and rank this answer if this helps!... good luck

Posted on Jun 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Needs celluoid


Do you mean the starter solenoid ?

Jun 19, 2013 | 2006 Chrysler Town & Country

1 Answer

Need to locate the pcm on 2004 town and country


I have 1999 town and country and it is located just in front of the battery. It is aluminum with cooling fins on it.

Jan 13, 2012 | Cars & Trucks

1 Answer

I had to chang the engine computer on my 02 town and country. Do I have to take it to chrysler to get it reprogramed for my van?


the town and country has a PCM ( power control module, located in front to the battery ) and a FCM ( front control module located on the front of the relay center next to the battery ) if either module is replaced they need to be programed with a DRBIII, so you will need to see your dealer.

Sep 09, 2011 | 2002 Chrysler Town & Country

1 Answer

Cabin Air Filter replacement. Where is it located on a 2006 Chrysler Town and Country?


there is a panel just above passengers feet, take panel off and filter should slide out (down) you will see how panel is attached (no bolts)

Aug 03, 2011 | 2006 Chrysler Town & Country

1 Answer

WHERE IS THE BATTERY LOCATED IN A 2006 CHRYSLER TOWN AND COUNTRY


if you opened the hood, you cant help but see it. on left side.

Dec 01, 2010 | 2006 Chrysler Town & Country

Not finding what you are looking for?
2006 Chrysler Town & Country Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...