SOURCE: replace air filter 2002 Chrysler Sebring convertible
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
SOURCE: oil sending unit on 2004 chrysler sebring V6
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
SOURCE: 2004 chrysler sebring idle speed is too slow. HOw
why do you want your rpms higher while idling? you don't want them high because your gas bill will reflect that. slow shouldn't matter but if it's dying while on idle it could either be your mass air flow sensor or your fuel filter being clogged
SOURCE: 1999 Chrysler Sebring Convertible code P1495. I
Code 1495 = Leak Detection Pump Solenoid Circuit
Remove the connector from the solenoid (should be on the back wall,
just to the drivers side of the air-hat). You will have the solenoid
to check and the harness. What you want to measure is the voltage
coming from the harness and the resistance of the solenoid.
Turn the
key to the "ON" position but do not start the motor; the voltage at
the connector should be at least 10V or more,.now, check the
resistance of the solenoid (should be around 35 ohms).
Hope helps.
61 views
Usually answered in minutes!
×