Where can i find the knock sensor in a 2005 pt cruiser touring edition? trying to replace it

mike loshbough

• 1011 Answers
• Posted on Jan 25, 2009

SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?

the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?

mike loshbough

• 1011 Answers
• Posted on Jul 31, 2009

SOURCE: 2005 pt cruiser misfire low rpm

Have your plugs and wires checked for replacement:)

SOURCE: '05 PT Cruiser O2 sensor problems.

I had a similar problem with my car. It turned out the O2 sensors were fine and the issue was a leak in the throttle body causing the engine to run lean. If you have an ODB2 scanner you can look at fuel trims, etc and will be able to tell.

SOURCE: how do I replace a 2005 pt cruiser camshaft sensor

Camshaft sensor sit in the end of the cylinder head, drives side, just unscrew both little bolt's from sensor, remove sensor, and install new cam sensor, no reprogramming needs to be done.

SOURCE: location speed sensor pt cruiser 03 touring car do

It sounds like the module is in limp mode. The speed sensor is most likely the cause, but it can be some other things as well. A scan will give a code stating the problem area.

The speed sensors are on the side of the trasmission that faces the front of the vehicle. There are 2 of them, and they are the same sensor. One is an input speed sensor located closest to the engine, the other is the output speed sensor.