SOURCE: checking computer says engine coolant temp too low
the stat is in the upper rad hose follow the upper hose to the mtr the hose goes to the themostat housing there are two bolts holding it on look to the left of the housing you will see a sensor that is screwed into the intake manifold when you remove that sensor coolant will run out
SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: Location of Low Coolant Sensor on a 1998 Buick
did you mean coolant level indicator module, it is located on the right inner part of the radiator
SOURCE: 1994 buick custom regal engine 3.8 engine coolant
Hi there. This answer is on previous question -->> temperature_cooling_sensor_located
For 3.1L and 3.8L engines, remove the air intake duct or intercooler-to-intake manifold tube, as applicable.
Hope this helps (remember to rating thia free answer).
816 views
Usually answered in minutes!
×