2006 Toyota Corolla Logo

Related Topics:

Nora Brewer Posted on Mar 15, 2017

I just got a 2006 Toyota corolla,has a coolstart remote, that the seller never even knew about.I started it by accident one day, and cannot figure out which button is which. Has 4 on front, 2 on side.

5 Related Answers

Anonymous

  • 1861 Answers
  • Posted on Sep 25, 2008

SOURCE: 2006 toyota corolla - rotors

The large bolt that you see is the nut that holds the axle shaft to the hub. You do not need to remove it to remove the rotors. You just need to remove the caliper & the caliper bracket. Normally, the rotors come off of the hubs easily, but sometimes, they rust onto the hub. My techs beat and beat and beat until they come off. With large hammers. Note that after they are beaten off, the rotors are no longer viable for re-use.

Ad

Anonymous

  • 65 Answers
  • Posted on Nov 29, 2008

SOURCE: need belt schematic for 2006 toyota corolla

I can get you a diagram on monday but it goes from the alternator to the power steering pump then around the tensioner pulley then around the crank pulley then to the a/c compressor then pull on the tensioner to give you some slack and slip it on the waterpump.I hope that helps.Let me know if you still need the diagram

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Feb 10, 2009

SOURCE: 2006 Toyota Corolla wont start

this sounds like the electric fuel pump in the fuel tank has failed, replace the pump and filter togeather.

Anonymous

  • 2 Answers
  • Posted on Apr 06, 2009

SOURCE: removing door panel in 2000 toyota corolla

remove phillips scew and the door handle. remove padded arm rest on the door by lifting it up, and remove 2 screws. You can use a panel tool to remove the plastic toggle like pins holding the panel border in. Be as gentle as possible they may break due to becoming brittle.

Anonymous

  • 20 Answers
  • Posted on May 24, 2009

SOURCE: How do I replace the fuel filter on my 2006 Toyota Corolla?

ITS A LIFETIME FILTER AND WITH REGULAR USE, SHOULD NEVER NEED TO BE REPLACED

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to rectify 2006 corolla rear wheel drive wheel alignment issues with non adjustable rear end (toe in & camber). Is there any aftermarket kits or other ways to solve these issues.

Since the rear wheels do no steering, there is no toe in or camber adjustments. Why do you believe you need these to be adjusted? Has the car been in an accident and the rear suspension is out?
0helpful
1answer

Need diagram for replacing belt on 2006 toyota corolla

good day Sir, try this link owners manual i hope this will help you.
0helpful
1answer

I ran my 2006 toyota corolla into the garage door! It was at a very low speed so thankfully it only did a little damage. I need to take the right side of the front bumper off and so a few minor repairs,...

I dont own a toyota so i couldnt tell you for sure..but i do know one thing for sure is that you must be careful that you disable the air bag sensors which are usually near the front bumper on most cars before you work on the bumper so that you dont set them off by accident.
0helpful
1answer

How do I relace the SPARK PLUGS in the 2006 Toyota Corolla?? How do I remove the covering as you look at the engine.

good day, just try to loosen the 4 screws at the top then you can pull the cover out. hope this helps, have a nice day
2helpful
1answer

06 corolla dead in driveway code po607

Just get a refund. The computers are expensive and if it died in 5 days, there had to be a problem that the previous owner knew about. GIVE IT BACK QUICK befor more problems occur!
1helpful
1answer

2006 Toyota Corolla. The driver's door won't work with remote.

the actuator might have been disconnected from the lock, its attached inside the door, with a metal rod that clips into the actuator, check it out, might be a easy fix, good luck and god bless, please rate me!
0helpful
1answer

Car's check engine light came on and died while driving

Sorry but there is no way to give you an estimate. The mechanic will hook your car up to a scan tool and will read the stored codes and then will start to preform some diagnostic work to figure out what your problem is. He will then be able to create an estimate for you.
0helpful
2answers

Car was working fine and then the car would not start. Checked the battery and fully charged. Tried to start again and it started. Turned off car and nothing again. Not even a cranking sound!

Depending of the type of car, and the starting system, you could have up to two starter solenoids on your vehicle. These components sent current to the starter during ignition but your problem sounds like the solenoid or even some of the connections throughout the starting system.(Starter motor, Ground strap, Pos+ cable from battery to solenoid.)
Not finding what you are looking for?

138 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...