SOURCE: Toyota Land Cruiser check timimg Belt
Hi,
I am assuming that you have a series 80 diesel engine and that it has run for about 100,000 kms hence the warning light and the changing of the timing belt. Based on the instructions of its repair manual you need to "remove the
grommet off from the speedometer and turn off the lamp by pushing the
warning light reset switch, then replace the grommet." Alternately, you can try to reset the entire computer of the vehicle by removing the battery cables for a couple of minutes. Pls note that some car radios/head units would revert to security default (ask for a code) when power is completely removed.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
SOURCE: TIMING BELT MARKS DONT MATCH AFTER ENGINE TURNED OVER
dont worry about that you will have to turn the motor over 40 to 50 time before those timing belt marks line up again if your pulley marks line up correctly thats all you have to worry about
SOURCE: I have a Land Cruiser 2000 model HZJ105L diesel.
I have a 2007 Toyota LC HZJ105L and the fuel gauge, battery gauge, indicators, dash lights, tachometer, speedometer, aircon, fan and wipers don't work. I have checked the fuse box under the bonnett and both fuse boxes inside and cannot find the blown fuse? Can anyone help out??????
SOURCE: hi how can reseating t-belt sevice light on toyota
heres proper reset of the t-belt indicator.. 1.) key off. 2.) pressODO reset button and hold,turn the key to on,hold ODO button for ten seconds. 3.) release ODO reset button,press once and release within 3 seconds...4.)ODO will then read 10 or 15 depending if it"s a 100,000kms cambelt or 150,000kms belt. 5.)if 10 then press the ODO button (on off) till it reads 20.. 6.)if 15 then press it until it reads 15 again. 7.)once it reads 15 or 20 press and hold ODO reads current km travelled.. 8.)start engine and light will be out.
214 views
Usually answered in minutes!
×