I have a broken or unattached yellow wire near the firewall side of the engine. a single wire coming from a connector on top of the timing cover and running along the timing coverback towards the firewall. wonderingg if this is the crank sensor wire
SOURCE: change spark plug wires on 04 kia sedona
REMOVAL OF THE PLUGS:
Do not attempt any maintenance on spark plug if engine is hot.
1. Disconnect negative battery terminal.
2. Carefully remove high-tension leads.
3. Use compressed air to blow any dirt or debris from around spark plug hole.
4. Check that spark plug fits squarely in spark plug socket and remove spark plug.
Raise a vehicle and install SST(OK552 131 001) in order to replace cylinder 2, 4, 6 spark plug.
INSTALLATION:
1. Install spark plug into cylinder head.
Tightening torque : 18~22lb-ft (25~30N·m, 2.5~3.0kg-m)
2. Reconnect high-tension leads.
3. Reconnect negative battery cable.
Hope this helps and simple to understand. Good luck
SOURCE: My 04 Kia Sedona cranks but doesn't start up?
Changing the crank sensor is a guess.
It may be the problem, but throwing parts at it can be expensive.
First, verify if you have spark and/or fuel, then go from there.
SOURCE: how to remove crank pulley on a 04 sedona?
put a big bar and socket on the pulley nut ,then crank engine ,make sure bar is wedged in well and nobody is near it when refitting make sure you use some contact adhesive on the thread when refitting
SOURCE: hi i have a 04 kia sedona 2.9 crdi starting problem
check fuel pressure with engine off but key on, sounds like a possable problem with the pressure regulator, or maybe a weak fuel pump or bad fuel filter
SOURCE: How do I change the Sparkplugs on a 2005 kia sedona van?
it sounds like you removed the intake manifold if not you need to remove it. Use a 5/8 spark plug socket 2 extensions and ratchet I hope this helps you
272 views
Usually answered in minutes!
×