SOURCE: Olds Ciera 1996 turn signal/cruise/wiper
hello, hope this helps ya out...
1. remove th steering wheel retaining nut and remove the steering wheel.
2. remove lock plate cover with a couple of screwdrivers
3. push in lock ring enough to remove ring retainers.
4. remove lock plate
5. take off the retaining screws to remove the turn signal lever.
6. loosen and remove screws ro the hazard switch(3 i think)
7. remove trim panel under the steering wheel and locate the wire harness connected to the switch.
8. remove retaining bracket nuts and bolts on steering column and lower the bracket.
9. then you are able to remove the wire harness and switch.(you may want to tie a string or wire so that you can feed the wires back thru easier when installing the new one)
Install is the reverse of this. Please rate my answer so I know if I was of any help to you, good luck!!
SOURCE: 95 olds cutlass ciera,31,000 origional miles is cutting out .
check air and fuel filters most likely the fuel filter and possible tune-up
412 views
Usually answered in minutes!
×