Location of the crankshaft position sensor in a 1999 crysler concord 3.2

SOURCE: crankshaft sensor location and replacement procedure

It is on the rear of the engine, passenger side. You need to access it from the underside and it is halfway up the block between the head and the oilpan. It is real close to where the engine and transmission meet.

Greg Bernett

• 2993 Answers
• Posted on Jun 25, 2009

SOURCE: how can i replace the crankshaft position sensor

Fig. 2: Location of the crankshaft position sensor on 2.4L engines

Ned C Cook

• 3433 Answers
• Posted on Sep 28, 2009

SOURCE: need location of crankshaft position sensor on a

The crank sensor should be found at the front by the crank pully. it is bolted to the engine wuth a wire connection plug on it.

SOURCE: 1999 chrysler 300m wont crank, code P0340

Sounds like the timing belt broke. Unfortunately this vehicle was not equiped with no contact valves so if that is the case you will need to have the engine and Head rebuilt. If the crank position sensor can't sense the position of the crank it should shutdown the electrical to keep you from damaging your engine.

SOURCE: location of crankshaft position sensor for 2003

Had this problem. The crankshaft position sensor (on 2003 non-turbo) is located directly under the starter. The Haynes and Chilton books will tell you the complete opposite. They state that it is located near the alternator. WRONG. Oh, it is really a pain to get to FYI.