1999 Chrysler Concorde Logo

Related Topics:

Raymond Farmer Posted on Mar 09, 2017

1999 Chrysler Concord fuel pump removal,is there an access door in the trunk of the car?

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jul 07, 2008

SOURCE: Fuel tank door hinge

Found on-line at other sites.


[Removing/Repairing Gas Filler Door Hinge: Tip from Bill Peyton]   The gas door hinge will break if pushed forward.  This is usually done by moving around the car with the door open, or by curious children.  The repair job can be done completely from the exterior. 
 
The black plastic hinge is held in place by four plastic rods.  When pushed through the body of the car, they expand four rubber sleeves located on the interior, thereby holding the whole thing in place. 
Remove as follows: 
Open the door, and using a small punch, push the four plastic rods through to the interior of the car.  The door will now come out.  Note the position of the spring and the hinge.  Remove the spring from the old hinge, and either cut or pry our the old hinge.  This is a black plastic piece. 
The ends of the new hinge are tapered to make it easier to insert into the gas door.  Clip the spring back into place. 
Now for the hard part.  You will see on the new hinge four plastic rods.  These are held onto the hinge by four small connections, all molded into a single piece.  On the other side of the hinge are four plastic “flowers” split into four pieces.  You will need to push the plastic rods through the “flowers”, once the “flowers” are pushed through to the interior of the car.   Since the rods are not free floating, they tend to break off and fly away unless you hit them squarely.  If this happens, put a little taper in the ends, place them back in the hold, and push them through.  A punch and a hammer will be essential.  Alternatively, you can break the rods off while the piece is off the car, insert them manually, and drive them in again with the punch.
 

Ad
dennymulford

Dennis Mulford

  • 1055 Answers
  • Posted on Mar 05, 2009

SOURCE: is the fuel pump removed from the trunk of a 2001 grand prix

no you must drop the tank

Anonymous

  • 37 Answers
  • Posted on Mar 21, 2009

SOURCE: Stuck Jeep grand cherokee trunk door 1999 model

you will need to replace the the door lock actuator for this door. when you unlock the doors do you hear a loud noise yep that's the problem.

Anonymous

  • 1071 Answers
  • Posted on Jul 21, 2009

SOURCE: Removing fuel pump from 1993 volvo 940. I know

you have to spin the pump a little and work around pay attention to how it comes out my first one i got excited and couldnt get it back in but i lowered the tank a little and it was easier

Anonymous

  • 38 Answers
  • Posted on Dec 15, 2009

SOURCE: 1999 Cadillac Deville - How to replace fuel pump?

Hello,

Unfortunetly Cadillac does not have an access panel for fuel pump access until the newer years. You will need to drop the tank. Also, don't let the tank come slamming to the ground, make sure you take it slow so you dont dammage the lines to the sending unit.

Good Luck!

Testimonial: "Thank you for your response"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Can I cut an access panel to access the fuel pump in a 2000 Chrysler concord?

not advised but do at own risk ---their are wires brake lines fuel lines and vehicle frame supports all in area above fuel tank
0helpful
2answers

Can I get an answer to my questions on the 1999 fuel pump replacement,is there a access door in the trunk that I can remove to get access to the fuel pump door

drop the tank, pita but that's how it's done unless you make your own access door , under the rear seat or in the trunk
0helpful
1answer

Also 1999 Chrysler Concord where can I find the fuel filter

The Fuel Filteris located: Under vehicle, center, below seating area, mounted ontop of fuel tank, in fuel pump module.Check this link out. Repair Guides Fuel Filter Removal Installation AutoZone com
0helpful
2answers

2005 Chrysler 300 Fuel pump removal replacement

There is a company that independent auto repair shops get their information from, this same information is available inexpensively for people that work on their own cars.. The information is year make and model specific, covering repair procedures, torque specifications, fluid capacities and specifications, service bulletins, component locations, wiring diagrams ect.... Alldata is very easy to navigate http://bit.ly/AllData_Repair_Manuals_Online
3helpful
2answers

How do you change the fuel pump? is there a access panel and if so where is it located?

Removal & Installation
To Remove:


  1. Before servicing the vehicle, refer to the precautions at the beginning of
    this section.
  2. Release fuel pressure.
  3. Remove or disconnect the following:

    • The rear seat





      Electrical Connector
      dod_intrpd_fuel__tank_elec_conn.gif



    • The fuel pump electrical connector





      Battery Cable
      dod_intrpd_batt_conn.gif



    • Battery cable

  4. Raise and safely support the vehicle
  5. Remove or disconnect the following:





    Fuel Tank Drain
    dod_intrpd_fuel_tank_drain.gif




    • Fuel from fuel tank





      Stabilizer Bar
      dod_intrpd_stab_bar.gif








      Stabilizer Bar and EVAP Canister
      dod_intrpd_evap_cann.gif



    • The rear stabilizer bar brackets from body
    • Stabilizer bar toward rear of vehicle





      Fuel Filler Tube
      dod_intrpd_filler_tube.gif



    • The fuel filler tube from fuel tank





      Fuel And EVAP Lines
      dod_intrpd_fuel_evap_lines.gif



    • Fuel and EVAP lines

  6. Position transmission jack under fuel tank assembly.
  7. Remove fuel tank straps bolts passenger side first.
  8. Lower fuel tank and remove the purge line and vent line.
  9. Disconnect fuel line from fuel pump module by depressing quick connect
    retainers with thumb and fore finger.
  10. Slide fuel pump module electrical connector lock to unlock.
  11. Disconnect the electrical connection from the fuel pump module, by pushing
    down on connector retainer and pulling connector off of module.





    Fuel Tank Locknut
    dod_intrpd_fuel_tank_tool__nut.gif



  12. Use Special Tool # 6856 to remove fuel pump module locknut.
  13. Remove fuel pump and O-ring seal from tank. Discard old seal.

To Install:


  1. Wipe seal area of tank clean and place a new seal in position in the tank
    opening.





    Fuel Tank Locator
    dod_intrpd_fuel_pump_loctr.gif



  2. Position fuel pump in the tank.

    • Make sure the alignment tabs on the underside of the fuel pump module flange
      sits in the notches on the fuel tank.

  3. Position the locknut over the fuel pump module.
  4. Tighten the locknut using Special Tool # 6856

    • Torque to: 40.5 ft. lbs. (55 Nm)

    CAUTION
    Over tightening the pump lock ring may
    result in a leak.

  5. Position the fuel tank on the transmission stand.
  6. Install or connect the following:

    • Fuel pump electrical connector into hole in the body
    • The purge and vent lines
    • Fuel tank and tank straps
    • The fuel filler tube and tighten the clamp
    • The stabilizer bar and install bolts

  7. Lower vehicle.
  8. Install or connect the following:

    • The fuel pump electrical connector that is in the rear seat
    • The rear seat
    • The battery cable

  9. Fill fuel tank.
  10. Use the DRB or equivalent scan tool to pressurize the fuel system.
  11. Check for leaks.


prev.gif next.gif
1helpful
1answer

How do i replace rear tail light bulbs and back up light bulbs on 1999 Chrysler concord XI

You will have to access the bulbs through the inside of the trunk either by removing the taillight assembly or just R&R the bulb.
5helpful
3answers

How do I replace the fuel pump on a 1985 300ZX? do I have to remove the fuel tank? I was told that I could access it from the back (hatchback) but I don't see how.. Thanks!

its in the center of the trunk there are some screws that hold the lid down..remove them..then remove the second set.twist the (twist left) fuel pump then pull straight up...you might have to wiggle it a little to get it out....then replace it.and put it back together
0helpful
2answers

Where is fuel pump? easy to change out?

INSIDE THE GAS THANK IS NOT EASY TO CHANGE
1helpful
1answer

1999 Chrysler Concord won't start at times and dies while driving

Have somone check the timing belt make sure it has not jumped any teeth common problem on a old car with high mileage.
Not finding what you are looking for?

295 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...