SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana
On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.
SOURCE: 2000 Pontiac Montana hood won't open
Many times if you pull on the release and have someone give a sharp "bounce" on the leading edge of the hood it will get the latch to work. If you get it open, make sure you spray the mechanism with some wd40 to free it up.
SOURCE: changing sparks plugs in a 2000 pontiac montana
remove the ignition coil pack ( 2 10mm bolts on front of it and 2 13 mm nuts on the back side) u will need a long extension and deep socket for the back ones , and unplug all electrical connectors and remove it from the vehicle and you should be able to reach the back plugs without a problem.
SOURCE: Pontiac Montana SV6
For instructions on how to program remotes and keys check website below, I use these and they are usually very accurate. This website does state that on your vehicle, special equipment is needed to program a key fob, as there is no onboard programming for it. However, there are programming instructions for transponder keys.
http://www.programautokeys.com/
http://www.programautokeys.com/
SOURCE: Where is the starter on the 2000 montana
Fowwow the large red wire from the battery and it will lead you to it. It will be on the lower part of the engine near the flywheel.
511 views
Usually answered in minutes!
×