SOURCE: 2003 Honda Odyssey Brake light replacement
open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).
SOURCE: how to change fog lights bulbs on my 2005 honda
To Install:
SOURCE: Our 2005 Honda Odyssey had a check engine light / misfire
When a cylinder mis-fires there is a reason. The dealer should have told you that. Most likely you have a fouled out spark plug. Which means you need new spark plugs and maybe wires. All this would be covered in a standard tune up. Once the bad spark plug is replaced, the computer will quit registering a mis-fire. Please give good ratings, they meen a lot to us.... Thank you
SOURCE: Honda Odyssey 2005 with vibration/growl at
if this problem only happens when the eco light is on, then you prob have a bad rear engine mount. these vans have active front and rear engine mounts. when the engine is in VCM mode(operating on 3cyl) the front and rear engine mounts control the engine vibrations. when the rear one goes bad it connot control the engine vibrations. the rear mount can be visually inspected for failure(if its resting on itself), or on a test drive with the active noise control turned off. or engine brake torquing.
SOURCE: how to change plugs on honda odyssey 2005
you will need
8mm
10mm
5/8 spark plug socket
3/8 ratchet
3/8 extension (it could be 4in and longer)
and spark plugs factory plugs are pregap iridium
spark plug torque is 13.0 lb.ft
coil torque 8.7 lbf.ft
spark plug part # NGK 1zfr5k-11
# DENSO pkj16dr-m11
and spark plug anti seize on spark plug thread
what you need to do is remove the plastic cover 8mm socket or 10mm sockets
now remove the spark plug covers and remove the spark plug coils too 10mm head bolt you will need a 5/8 spark plug socket and a 3/8 ratchet and a 3/8's extension too
you need OEM spark plugs they work the best
hope this will help
73 views
Usually answered in minutes!
×