2001 Oldsmobile Alero Logo

Related Topics:

J
Joan st- germain Posted on Mar 05, 2017

J'ai une automobile Alero d'oldsmobile 2001. Quand j'allume le moteur de mon auto, le dessin check engine appara?t. Pourquoi?

5 Related Answers

Anonymous

  • 2 Answers
  • Posted on Nov 22, 2008

SOURCE: 2001 oldsmobile alero

If the "check engine" or "service engine soon" light is flashing, it could be the engine is miss firing. This could be caused by a bad spark plug wire or spark plug. How old are they? After changing the plugs on my 2001 Olds Alero (at 125k miles) I noticed the engine occasionally miss fired and the "service engine soon" light started blinking. I used a timing light to determine which cylinder was miss firing and changed that spark plug wire. Advise would be to change the whole ignition wire set, but I was cheap and just changed the one wire, which cost $23 from a GM dealer. That was 14 months ago and the car runs great.

Ad

Anonymous

  • 749 Answers
  • Posted on Aug 30, 2010

SOURCE: i have a 2000 oldsmobile

P0105 - MAP Sensor Circuit Insufficient Activity.If it is the 3.4 or 3.1L engine The Map sensor is located towards the back of the engine by the coil packs.Would verify that it is plugged in and also that the vaccum line going to it is not cracked,If all this checks ok then map sensor may need replaced.

A

Anonymous

  • Posted on Jun 13, 2011

SOURCE: I HAVE A 2001 OLDSMOBIL

Reset it why?

You do not care that your car needs to
be checked for codes,diagnosed & repaired,
because you have an OBD2 System Malfunction

Guess you haven't been around since 1980 when
these systems came out ,30 years ago

No owners manual either?

ZJLimited

ZJ Limited

  • 17989 Answers
  • Posted on Aug 19, 2011

SOURCE: ALERO 2002 ABS LIGHT ET

It is very possible that he did not need to remove the wheel to check it out. Many times if you use the scan tool to check for codes that are stored in the computer, to find out why the light came on, the computer will tell you basically what the problem it. And a bad wheel bearing can cause the Anti Lock and Traction Lights to come on, because when they go bad, that causes the wheel speed sensor to become defective and the sensor in turn will set the light and make it come on. The Engine light comes on because the others came on. So, chances are pretty good that he is correct and did not feel the need to remove the wheel to inspect the bearing.
------------------------------------------------------------------------------------------------------------------------------------------------
Il est tr?s possible qu'il n'ait pas besoin d'enlever la roue pour v?rifier. Plusieurs fois, si vous utilisez l'outil d'analyse pour v?rifier les codes qui sont stock?s dans l'ordinateur, pour savoir pourquoi le voyant s'est allum?, l'ordinateur vous dira ce qui en fait le probl?me c'est. Et un roulement de roue d?fectueux peut provoquer le verrouillage anti traction et Lumi?res ? venir, parce que quand ils vont mal, qui cause le capteur de vitesse de roue pour devenir d?fectueux et le capteur ? son tour mis en lumi?re et faire venir de suite. La lumi?re s'allume moteur parce que les autres sont venus de suite. Ainsi, les chances sont assez bonnes qu'il est correct et n'a pas senti le besoin d'enlever la roue pour inspecter le roulement.


Hope this helps.

airjer995

Jeremy W.

  • 5332 Answers
  • Posted on Nov 28, 2012

SOURCE: need to replace water pump on 2001 oldsmobile alero

What engine? Four cylinder or v-6

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

Pourquoi mon gmc sierra 1500 2003 ne reste pas en marche quand je d?marre le moteur.et ensuite ne d?marre plus

Plusieurs choses : 1- Pression d"essence
2- Systeme d,ignition feu aux bougies
3-Doit sortir les codes de defaillance avec un moniteur.
4-De l,eau dans l,essence
5-Mise au point (Bougies ,cap , rotor,nettoyer le trottle body, changer filtre a air, filtre a esscence.etc
Hope it helps.
0helpful
1answer

J ai une perte de liquide de refroidissement qui semble venir du haut du moteur coté de l habitacle. La perte se produit quand le moteur prend de la chaleur. C est causé par quoi?

Moteur 4 cyl ou v6 2.8l, 4.3l?

Possiblement expansion entre le bloc moteur et tubulure admission(intake). Certains modeles coulent avec l'age. Remplacer les joints d'etancheite et le probleme devrait se regler. Desole pour les accents. Ordi barre sur clavier anglais.
0helpful
1answer

Mon tapis roulant sportcraft tx390 ,a commencer a sentir le brule 3 jour apret que jais du ajuste mon tapis car il avais tendense a bouge sur la droite et frote donc jais fait un ajustement et cest...

bonjour, quand je fais partir mon tapis roulant il fonctionne pendant quelques seconde, ensuite le chiffre ( 3 ) s`affiche dans le coin gauche et il cesse de fonctionner, pourriez-vous m`aider? Merci
0helpful
2answers

Silverado 2004 moteur 5.3 litres avec un cathelisseur neuf de gm et le code po 157 allume quand je lui pesse dans la face

2004 silverado 5.3 liter engine with a cathelisseur gm nineinches and code 157 lighter when I pesse in the face ???????????????????????????? This makes NO sense!
4helpful
2answers

J'ai une Aveo5 2004 la semaine derniere Le moteur à faire sauter une cause de ma courroie de distribution 102mille kg, j'ai fait le changeur de moteur, courroie de distribution, pompe a eau, fillage,...

PO300 CODE EST PLUSIEURS CYLINDRES MISFIRE.YOU POURRAIT AVOIR UNE MAUVAISE ALLUMAGE OU LES BOBINES BAD BOUGIES ET WIRES.LOW COMBUSTIBLE PRESSURE.DUE POUR BOUCHER COMBUSTIBLE FILTER.YOU AURAIT PU MOTEUR MECANIQUE FAULT.BAD LEAKING MOTEUR VALVES.
0helpful
1answer

Information

what do you mean by the first cylinder was the cause, as in the injector was bad or that the cylinder was bad?

if it is the injector, replace it.

if it is the cylinder, the engine needs a rebuild.
0helpful
1answer

Puis-je avaoir un support en fran?ais

Ton check engine n'a rien avoir avec les bougies.

Pour les cables, au pire remplace les une par une, comme ca tu te trompes pas.

Devrait emmener ca au garage pour ton bruit, sinon dit moi avec plus de details de c quoi ce bruit la. Bonne chance.
Not finding what you are looking for?

81 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...