1992 Buick Regal Logo

Related Topics:

Brian Becker Posted on Mar 03, 2017

I need a picture of the inside of the door latch assembly for a 1992 Buick regal gran sport

5 Related Answers

Anonymous

  • 11 Answers
  • Posted on Feb 17, 2009

SOURCE: 94 Buick Regal Gran Sport

filter is on the passenger side of the motor just behind and below the power steering pump if you look at the motor from that side you will see it

Ad

Anonymous

  • 3533 Answers
  • Posted on Mar 21, 2009

SOURCE: Need diagram of 1993 Buick Regal Gran Sport suspension

try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you or you can try www.schramauto.com or call them at 1-800-292-1032

Anonymous

  • 1776 Answers
  • Posted on Aug 31, 2009

SOURCE: How to replace front struts on 1992 Buick Regal

Go to the autozone.com website and register the car. It doesn't cost anything and will give you access to an online repair manual for the car. The steps for replacing the struts for your car can be found there. I checked. Hope this helped and best wishes.

Anonymous

  • 130 Answers
  • Posted on Jan 15, 2010

SOURCE: 1994 Buick Regal Gran Sport shuts off once engine warms up.

it might be a bad ignition moduale. or could be a bad ignition coil

Anonymous

  • 209 Answers
  • Posted on Apr 15, 2010

SOURCE: WHERE IS COOLANT TEMP SENSOR

On the top of the thermostat housing

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do i get my 1996 buick regal gran sport 4D sedan out how do i get my 1996 buick regal gran sport 4 door sedan out of "safe mode" or "limp mode"

run the fault codes to find the reason for the limp mode
fix the faulty parts
reset the ECM using the scan tool
if you don't fix it will go straight back to limp mode
1helpful
1answer
0helpful
2answers

Searching for cild lock location 92 buick regal?

look on the door by the latch mechanism
3helpful
1answer

How do you install a vacuum modulator in a 94 regal

Remove the vacuum line at the modulator. Remove the bolt and the modulator assembly retainer. Remove the modulator assembly. Reverse order to install.

NOTE: if the modulator valve comes out of the bore when removing the modulator vacuum assembly, note the orientation of the valve and reinstall it in the bore before installing the new vacuum modulator assembly. (see picture)


dttech_161.gif
0helpful
1answer

Front door handles wont work from outside

You have a rod that goes from your door handle to the latch opener, inside the door panel. It has probably came off. You will need to take off your door panel to get to it. There are just a few screws on the corner of the panel. Remove them and then you will need to move the plastic and foam in the inside of the door. After this, you should be able to get to the rod. Hope this helps you.
0helpful
1answer
0helpful
1answer

Low voltage tps senser.

Not likely getting a bad TPS.Your TPS runs off a 5volt reference wire.Using multimeter with key on engine off Check to make sure you have your 5volt reference check for any deformed terminals or broken wires inside insulation.
0helpful
1answer

Driver side power lock will lock but not unlock

The only way to really see the problem is by removing the door trim panel. This will allow you to see if is the actuator is moving, and how far, along with noting any interference of lock linkage movement. Hope this helps.
2helpful
1answer

1994 buick regal door

first step is to remove inside door panel. look around panel for any visable screws note most are hidden remove all to free panel along bottom of panel are plastic clips gently pull near clips to release if panel is hard to pull off look for more scews like under power window switch which may pop out and have screw undernieth near door handle and under arm rest. once panel is off look indoor near outside handle and u should be able to see whats going on u may just need new clip to hold latch rod to handle or may need new handle from a salvage yard or auto parts store but first step remove panel hope this helps u
1helpful
1answer

Need diagram of 1993 Buick Regal Gran Sport suspension

try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you or you can try www.schramauto.com or call them at 1-800-292-1032
Not finding what you are looking for?

79 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...