I need wiring diagram for 1999 mazda 626 ignition wiring to use on start button

SOURCE: 2000 Mazda 626 brake lights

It may be the switch on the brake pedal, it should be located on top of the brake pedal arn.

SOURCE: No spark?

Hi, common thing with the mazda was the coil or the ignition amplifier going faulty, both of which are located within the distributor, the coil ususally gives the symptoms you describe, a weak spark. The coil is the most common failure aswell for your vehicle i would recommend a new one, also make sure distributor is spinning as it could just be a case of a broken timing belt.

Good luck Davelee

SOURCE: my 1999 mazda 626 wont start

I HAVE A 1999 MAZDA 626 WONT START

SOURCE: spark plug wire diagram position from distributor

For the 1996 Mazda 626 2.0L DOHC In-Line 4-Cylinder:

Firing Order:
1 - 3 - 4 - 2

Cylinders:
.........(back).........
|..1....2....3....4...|
........(front)

Distributor:
__________
/////////////////| <---2
_______________
//////////////////////////| <------1
___________
///////////////////| <----C
_______________
//////////////////////////| <-------3
__________
/////////////////| <----4

Let me know if this helped and thanks for using Fixya!

SOURCE: where is 1999 mazda fuel pump located?my mazda 626

Hiya,
The fuelpump is located in the fueltank and is accessible by removing the rear seat squab. Under the squab is a service panel that will have a few screws holding it down. remove the panel and instead of removing the pump try giving it a firm rap with a hammer handle or piece of solid wood taking care not to damage the wiring or fuel lines exiting the top of the pump assembly. This may be enough to get the pump to work again.

Regards

GeckoNZ