SOURCE: wont start security light stays on
My girlfriend had the same problem, so we took it to the local dealer in Costa Mesa, CA and were told she needed a new engine to the tune of 5K. We decided to take it to our local mechanic and he discovered that the “ignition control box”, which apparently has the antitheft controls too and shuts the flow of gas to the engine because it thinks its being stolen when it malfunctions, was causing the starting problem. Once, the box was replaced it worked fine. Because the IBC controls antitheft, it will need to be “reprogrammed” be someone that has access to the proper equipment or the dealer. I think the whole thing was about $800 - $900. Sure beats $5,000
Hope this helps,
B
SOURCE: Car wont start, will not reset, security light always on
try locking and unlocking the drivers door with the key. [sometimes if you reach to un lock door through window it it sets off security]
SOURCE: car wont start has power has fuel and starter
The security system is activated. It kills the injector pulse ( signal) and on some modles the starter. You will need to try to relearn the system. First try to start the car, leave the key in the run position for 10 minutes. Cycle the key off, then cycle it to the run position again for 10 more minutes. Cycle it off again, then back to run for another 10 min. after the last cycle turn it off then try to start the car. It is a 30 minute relearn. If this does not work you will need a repair shop to replace the passlock sensor. Good Luck
Testimonial: "it was in the ignition and the security activated i had to replace the whole igintion key and all "
SOURCE: 1994 cutlass supreme security light stays on and does not start
their is two wires they are white and go in to a orange sleve that sould be on the ignition switch, that is part of the security system in the car. It runs down inside the colunm and plugs in uder the dash. This is most likley your problem, the wires might have a short.
SOURCE: starter wont crank on a 2000 oldsmobile intrigue
Check your manual if you have it. I believe you need to have the key in the ignition in the ON position for about 10 minutes to reset the security system.
114 views
Usually answered in minutes!
×