By following the instructions that came with it. If you do not have the manual go to the website of the maker of the system and download them, we do not them here.
SOURCE: programming new keyless entry remote
Yes...
1) Remove the "MALL PGM" fuse located in the glove compartment (see owners manul for location)
2) Turn ignition switch to "Accessory" then "Off" then back to "Accessory" witin 1 second. (accessory is opposite the forward direction key is normally turned for starting the vehicle)
3) Plug in drivers side seat belt.
4) Open and close a door (will hear a chime indicating in program mode.)
5) Press and hold both the "Lock" and "Unlock" buttons on the Fob and wait at least 7 seconds (may take longer) you'll hear a chirp or the horn will sound.
6) repeat step 5 for all other Fobs.
7) turn key to Off and replace fuse.
SOURCE: program remote keyless entry
1) Turn key from OFF to ON eight times within 10 seconds ending in the ON position.
2) After doors lock then unlock, press any button on the
remote being programmed.
3) The doors should lock/unlock to confirm programming.
4) Turn key to OFF and door locks should cycle one last time.
SOURCE: How do I program my new Suzuki keyless entry remote to work with our new SUV?
I bought a remote the other day and got these instructions with it. They worked!
1. Make sure vehicle is in Park
2. Press Vehicle Information button (has the icon of a car and an 'i')until 'PRESS *check mark* TO RELEARN REMOTE KEY' displays.
3. Press set/reset button. The message 'REMOTE KEY LEARNING ACTIVE' will display.
4. Press and hold the lock and unlock buttons on the transmitter at the same time for about 15 seconds. A beep will sound indicating that the transmitter is matched.
5. To match additional transmitters at this time, repeat Step 3. Each vehicle can have a maximum of four transmitters matched to it.
6. To exit the program mode, you must cycle the key to LOCK.
SOURCE: 1994 keyless entry programing
on the plug in point on the car where they connect scan tool use pin 4 and 8 jump them with papper clip this will cause door locks to lock and unlock then press both lock and unlock buttons on fob and it will take programing then remove paper clip all done.
SOURCE: Keyless Entry for 2003 Grand Am
This is a Dealer Option and they all Charge Different Prices. I have heard of Prices from 50.00 to 175.00 depending on what Options are on the Car.
152 views
Usually answered in minutes!
×