SOURCE: 2003 nissan altima 2.5l won't start
have you checked for the fire on spark plugs and also if fuel is getting to the intake
SOURCE: head light 2005 altima
you have to remove the bulbs from inside of the hood in the engine compartment. in some cars you have to remove some "pins' and remove the entire headlight assembly.. You then remove the holder where the lightbulb is located and replace the bulb.
SOURCE: 2005 altima fuel pump
The tank does not need to be dropped. There is a access panel either under the cushion of the rear seat or in the trunk. I have to replace the pump on my 02
SOURCE: How do I change brake light bulb on 2005 Nissan Altima
The first objective is to figure out which bulb you need. I had to replace the bulb for the largest light which was a Sylvania 3157. The next objective is to remove the dang plastic carpet holder/net clip. Recognize that it is a two part piece. Use a flathead screwdriver for leverage. Pry the cap off by levering the screwdriver in the slot on the holder. Then go behind the carpet and pinch the plastic pin still holding the holder in place. Next,pry off the while plastic pieces from the two bolt/nuts you'll need to remove (see manual). Remove the nuts and give the two screws a push from the inside so you can see how the whole light casing comes off. Pry it off from the outside. On the backside of the bulb holder, turn bulb base counterclockwise and gently remove. Pull bulb upward and replace. Do not touch glass on new bulb with your fingers (wear non-powdered rubber gloves). Make sure the bulb snaps in place. Follow these instructions in reverse. Smile, you just learned something new and saved yourself some easy money.
SOURCE: HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA
Removal & Installation
Negative battery cable
Fuel pump module harness connectors
Filler hose shield
Fuel pressure and return lines
Filler hose
Vent hose
Evaporative Emissions (EVAP) hose
Fuel tank skid plate
Fuel tank
Fuel level sender
Fuel pump
To install:
Fuel pump
Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm).
Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm).
Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm).
EVAP hose
Vent hose
Filler hose
Fuel pressure and return lines
Filler hose shield
Fuel pump module harness connectors
Negative battery cable
Car
not starting or turning over indicates towards multiple possibilities. It can
be issue with battery or weak battery. But if battery checks out ok, then it
can be starter issue or faulty alternator or problem with low fuel pressure or
no spark at spark plugs due to dirty spark plugs or faulty ignition
coil or injectors getting cracked or dirty and needs to be cleaned.
To
confirm the problem, the basic troubleshooting is required.
Click
this link below and follow the troubleshooting:------
http://technoanswers.blogspot.in/2012/02/car-starting-issues.html
---------
This will help.
Thanks.
196 views
Usually answered in minutes!
×