1999 Ford Contour Logo

Related Topics:

Javier Lomeli Posted on Feb 17, 2017

99 ford contour has no reverse only forward gears

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Feb 04, 2009

SOURCE: no drive gears

why should i tell you how i fixed it if your going to charge me 30 bucks to get an answer from you?
pay me 30 dollars for my solution!!!!!

Ad

Anonymous

  • 8 Answers
  • Posted on Mar 21, 2009

SOURCE: '99 V-6 auto Ford Explorer won't move when in reverse gear.

reverse clutches shot 800 - 1500 repair

fordexpert

  • 5692 Answers
  • Posted on Nov 28, 2009

SOURCE: ON MY FORD F150 IT WON1T GO INTO REVERSE. SHIFTS

Call a dealer about a new recall. There is another problem in the cruise control that is making it hard to put a vehicle into reverse. There are also problems with brake lights and dash indicators for the ABS all caused by the cruise control. This includes about 16 million various Ford products.

ZJLimited

ZJ Limited

  • 17989 Answers
  • Posted on Apr 02, 2010

SOURCE: 99 ford contour hazard flasher unit where is it

Flashers - REPLACEMENT

Turn Signal Flasher
(see Figure 1)

e21631a.jpg

Fig. 1: The turn signal flasher is located on the multi-function switch in the steering column

  1. Disconnect the negative battery cable.
  2. Remove the upper and lower steering column shrouds.
  3. Pull the flasher from the back of the multi-function switch.

To install:
  1. Install a new flasher in the multi-function switch.
  2. Install the column shrouds.
  3. Connect the negative battery cable.

Hazard Warning Flasher
  1. Disconnect the negative battery cable.
  2. Remove the knee bolster panel from the underside of the driver's side of the instrument panel.
  3. Grasp and pull the flasher from the connector located near the top of the steering column.

To install:
  1. Install a new flasher in the connector.
  2. Install the knee bolster panel.
  3. Connect the negative battery cable.

Hope this help (remember comment and rated this).

Anonymous

  • 370 Answers
  • Posted on May 12, 2010

SOURCE: On a '97 Ford Contour the transmission will not go

the gears in your trani are not meshing right you will need to take this into a shop since automatic trani's are nothing to play with. they are too intricat to do anything at home

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Ford crown victoria 99 won't go forward goes in reverse

You have a 4r70w transmission and more than likely a forward drum failure has occurred, seeing as reverse still works fine and no forward engagement. This is not an electrical problem, it is a hard part failure and the transmission will need to be disassembled to repair it. Forward drum failures are one of the more common failures in these transmissions. 4r70w no forward gears only reverse help needed Ford Truck Enthusiasts...
0helpful
1answer

My 1995 ford contour will not move forward or in reverse in gear

Check your Transmission Fluid, if it has a burnt smell you are going to need a rebuild. If it is the right level and clean check to make sure that the shifter is actually shifting the transmission by watching the shift selector lever on the transmission while someone shifts the gear shift inside the car.
0helpful
1answer

99 f150 4r70w

theres a pump for forward gears and one for reverse you need a ford tetech guy
1helpful
1answer

My 99 ford contour won,tgo into high gear, overdrive. shifts ok most ot the time except for high gear.

I would service the transmission before assuming anything is wrong or broke have it flushed and have a new filter and fluid put in.. Then go from there.
0helpful
1answer

On a '97 Ford Contour the transmission will not go into forward or reverse gears all the time. Hard shifting to start with then wont go into gear at all. Able to take out of park and go into neutral gear,...

the gears in your trani are not meshing right you will need to take this into a shop since automatic trani's are nothing to play with. they are too intricat to do anything at home
1helpful
1answer

No reverse / in all gears wants to go forward / no reverse . this is 1989 ford contour/automatic

CHECK THE CABLE FOR THE SELECTOR (GEAR SHIFT) IT MAY BE THE PROBLEM..IF NOT MAYBE TRANSMISSION IS FAULTY
0helpful
1answer

Tranny will go in reverse fine but it has no forward gears.

she's pooched, your forward gears in an automatic are completely separated from the reverse same with a standard either way your on your way to the tranny shop
1helpful
1answer
0helpful
2answers

My 99 cougar will not go in any forward gears but will in reverse

yes your forward lutches are goin out , time for a rebiuld or new tranny
Not finding what you are looking for?

321 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...