Car will not start no sound radio lights work 2005 mitsubishi endeavor

SOURCE: trying to change spark plugs

THEIR ARE ABOUT 9 BOLT TO REMOVE THAT SUPPORT THE INTAKE. 2 ARE IN THE REAR IN THE CENTER OF THE SUPPORT BRACKET THE 5 THAT ANCHOR THE INTAKE ITSELF AND 2 UNDER THE INTAKE THROTTLE BODY. ( 12MM) 3 HOSES ON TOP OF THE INTAKE TO REMOVE AND 1 SENSOR TO UNPLUG OR UNBOLT (8MM)THE ONE ON TOP OF THE INTAKE (TOP LEFT REAR). THIS WILL GIVE YOU ACCESS TO THE REAR PLUGS.
REMOVE THE SENSORS BRACKET OR HOLDER ( ON THE LEFT JUST LIFT UP TO REMOVE) AND SWING THE INTAKE TO THE RIGHT. UNPLUG THE PLUG MODULE THEN UNBOLT THEM (10MM).

SOURCE: why is my engin cooling fan staying on?

It's not completely abnormal for some cars to have the fans stay on for a short time after the ignition is shut off. If the fans are staying on as soon as you start the car and never going off the fan relay might be sticking. Also note that the fans will go on with the a/c switch.

SOURCE: the cruise control has stopped working on my 2005

One of your rear lights is blown out.

SOURCE: low tire light is blinking on a 2005 mitsubishi

You have low air pressure in a tire, check them all including the spare which may have a sensor installed.

Johnny Brown

• 5763 Answers
• Posted on Aug 12, 2011

SOURCE: Problem with the 2005 Mitsubishi

this light will go out after you inflate the tires to the proper pressure, make sure to check the spare tire also as sometimes they may have a sensor on them too.after all tires are set you may need to drive a few miles to reset the light. if the light remains on then you may have a bad sensor and will have to go and have each sensor tested with a tpms tool. the manufactor lists 10min of driving after setting all tire pressures even the spare tire and then light will go out. good day.