SOURCE: 2003 buick park avenue
take all screws out and pull out around the edges, should pop out, then lift up by the window.
or
Go to this website. It shows you how to remove the door panels. Ignore the part about side mirrors. kwmuth.com
with this model but I've had the inside door panels off several cars. + Then unscrew the armrest/handle (2 long screws). + Then run your fingers under the bottom of the panel (it is probably upholstered/padded hardboard) - this panel is usually held on by about 5 or 6 clips that pop out. + There may also be speaker wires etc if door-mounted speakers have been installed. + Then you should be able to gently slide the door panel up, so that the top ridge pops out from alonside the window glass.
SOURCE: The turn signal switch on 1998 Buick Park Avenue
REplacing of the turn signal switch invoves the removal of the air bag and steering wheel for acess to the switch ( reminder to unplug the yellow connector for the air bag under dash first).
SOURCE: Cannot change 3 rear spark plugs on 1999 Buick park avenue
there is a special tool for this job but I have cheated on this but you ned to be careful when doing this.The wishbone shaped mount on the front going from motor to front of vehicle, remove and it allows the motor to tilt.
SOURCE: How do I remove the rear door panel on my Buick Park avenue
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: 2000 Buick Park Avenue Service engine soon light
need to take car somewhere to have the code read with a scanner,try parts stores first some will do it for free if not the dealers have them
153 views
Usually answered in minutes!
×