2000 Lincoln navigator in theft mode i'm told there is a reset button under the dash

Question edited for clarity.
Question moved to model category.

Have a read. The Security System and Engine Immobilizer has locked you out.

https://www.fixya.com/cars/r29912554-changing_battery_not_create_problems

Press and hold any button on your remote within 20 seconds of the eighth turn. Hold the button for as long as 20 seconds until the locks automatically click and then release. Remove your key from the ignition to end the resetting process.

How to reset my anti theft on my car (Lincoln LS) - CarGurus.ca

CarGurus.ca https://www.cargurus.ca > Discussion-t7468_ds782699

I have a 2005 lincoln ls and I think my theft system has

JustAnswer https://www.justanswer.com > Lincoln Repair
Sep 21, 2017 - I have reset my button down by the left door panel That is not a Ford installed system.
1 answer · Top answer: Thanks, ***** ***** PATS system has nothing you an do DIY without a scan tool. A tool is needed ...

How do i perform the 2002 Lincoln LS anti theft reset?

Vehicle History https://www.vehiclehistory.com > questions > how-do-...
Jul 16, 2020 - Hold the button for as long as 20 seconds until the locks automatically click and then release. Remove Your key from the ignition to end the ...
2 answers · Top answer: To restore the 2002 Lincoln LS anti-theft system, You will start by Pressing and holding any button on Your remote within 20 seconds of the eighth turn. ...

How i get my lincoln ls out of theft mode

Fixya https://www.fixya.com > ... > LS > 2000 Lincoln LS
1 answer
Try turn the key in the drivers door three times or check this procedure in your Owners Manual. Hope helps. Read full answer. Feb 14, 2012 • 2001 ...

Presumably you disconnected the battery when you did the fuel pump and PCM? It also looks like the PCM has to be programmed with the VIN Number.

https://www.google.com/search?q=2000+lincoln+navigator+pcm


To reset the 2000 lincoln navigator anti-theft system press and hold any button on your remote within 20 seconds of the eighth turn. Hold the button for as long as 20 seconds until the locks automatically click and release. Remove the key from the ignition to stop the reset cycle.

How do i perform the 2000 Lincoln Navigator anti theft reset?

More on the anti-theft system

https://www.google.com/search?q=2000+lincoln+navigator+security+reset
..

start with fully charging your battery.

located under dash at drivers right knee area

Now a days the anti theft is built into the ignition switch. If the ignition switch starts going bad then you will most likely have problems with your anti theft. I would suggest that you replace your ignition switch and that should solve your problem. If you have any other questions please feel free to ask. I hope this helps.

the air ride suspension has level sensors under the vehicle, one of the sensors must be bad making the truck deflate the airbag or inflate it too much. you may need to have someone with a scan tool to access the air suspension module and check for fault codes. you can try turning the air suspension switch off for about an hour to see if the system will reset. the switch is located under the dash on the right side kick panel.

Hi!!
Check the R WIPER fuse and relay. They should be located on the under dash Fuse Box. Check your Owner's Manual for specific location.
Good Luck!!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

The is usually an off/on button located in the rear cargo area behind one of the side access panels.

Also, Your Lincoln may still be under warranty because the Lincoln products have a longer warranty that comes with the vehicle.

First remove outer wiper ,take off plastic guard there is a bolt underneath it remve wiper thenremove 2 screws that hold grab handle on inside of rear door.remove 2 plastic push tabs with removal tool.pry plastic cover off carefully removing push tabs with removal tool or flat blade screwdriver about 10 of them if I remember correctly pull bottom half of cover out of each conection and lift off at center. peel plastic from gate carefully as you have to put it back on.this exposes the motor disconnect grey plug to wiper motor ,three 8 mm screws hold motor to tailgate best of luck