Cars & Trucks Logo

Related Topics:

Mick Norris Posted on Feb 01, 2017

My speedo only works every now and again in my 80series land cruiser ive replace the speedo scensor but no difference

5 Related Answers

ryamha12

  • 87 Answers
  • Posted on Feb 27, 2010

SOURCE: replace heater core 96 land cruiser

remove the dash board then the heater control box

Ad

Anonymous

  • 87 Answers
  • Posted on Mar 02, 2011

SOURCE: when driving my land cruiser there is a whining

This sounds more like a u joint or internal transmission bearing to me. Normally if the speedo cable goes bad the speedo will not work. It could also be the gear that drives the cable too. I would have a trusted transmission expert look at it.

Anonymous

  • 4803 Answers
  • Posted on Jul 31, 2011

SOURCE: swapping out radio from salvaged

Is the salvaged radio EXACTLY the same as the original radio? Are you sure everything is plugged in correctly? If the radio is not EXACTLY the same. the circuits could be different and the wiring harnesses may not provide power at the correct pins on the radio. Also, do you have the security code for the salvaged vehicle? The code for your radio will not work in the salvaged vehicle radio.
Also check to be sure that you did not cause the fuses to blow when disconnecting/connecting radio components. If you attempted this job without first disconnecting the battery cable, there is a very good likelyhood that this has occured. Damage to the salvaged radio could also have occured if the salvage vehicle battery was not disconnected during removal of the salvaged radio.

Anonymous

  • 645 Answers
  • Posted on Nov 21, 2012

SOURCE: replacing 1997 toyota land cruiser v belts

The serpentine belt on the 1997 Dodge Caravan is responsible for keeping the front engine accessories working at all times. To change it, raise the hood, and locate the small belt routing diagram on the top/left side of the plastic fan shroud cover. Use the routing directions from the diagram to install the new belt.Use the bolt head that secures the tensioner pulley to the tensioner arm to rotate the tensioner. Slide the belt off of the tensioner pulley.may be it can help you and good luck------------------------------------------------------------------
zed-bull key programmer

nobody322

_-__-___-_

  • 20706 Answers
  • Posted on Jan 05, 2014

SOURCE: What should it cost to replace a heater core in a 1997 Land Cruiser

varies by series and what is used in your country, HVAC setups are not a world wide constant , nor are parts costs or labor.
why not diagnosis it.??????
1: is engine coolant NOT at 180F, (scan it or pyro gun it) dead simple
if car has a core water valve it must be open and flowing.
2: blow fan is dead, (on high must work)
3: air flow through core is not flowing.

if the core is back flushed, like it should be ever 2years then its
not packed up, remove hoses back flush it. does it flow
yes, good, its not bad (if not leaking incab)
no, its packed up, so blast it some more with a water hose.
now its fixed. simple huh and not removing it.
now #3
all above is good but #3
air flow, so move all the damper by hand , got heat now?
if yes, you just discovered why. bad damper controls'
the FSM covers in details how , for damper. read it.
in usa its also at alldata.com read it. read the damper sections .


Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer
0helpful
1answer

Speedometer needle

did you scan the ECU with a scan tool , and look to see if
the PID scan for SPEED is correct? "MPH" from VSS sensor?
Any stored DTC (errors)?
i will pretend , that you did and it was correct. (if wrong here , ask)
that means the speedo is bad. (if pcm sends right speed to speedo head and speedo head is wrong ,its is bad. replace it)
but do check all fuses, just in case...????
0helpful
1answer

HDJ81 1HD-T 80series land cruiser

The only way pressure can build up in the radiator is for combustion gasses to leak into the cooling system. This is usualy from a blown head gasket, a cracked cylinder head or a porous block. These things should have been checked for when the engine was rebuilt. Assuming it was done by an engine reconditioning service.
0helpful
1answer

Speedo and reverse lights not working

Reverse switch is faulty, this will blow fuse. Replace switch problem solved :-)
0helpful
1answer

Speedo wil not work with new sensor and new drive gear

hello, there is another speed sensor in the speedometer, replace the speedometer to resolve this.
0helpful
1answer

Speedo cable for 96 Landcruiser prado, cannot not find the cable suspect that it is broken, where do i find it?

1996 land cruiser-toyota - speedometer not working. I already replaced all speedometer sensors still not working. Need advice. Thanks.
0helpful
1answer

When driving my land cruiser there is a whining noise ,Ive been told that it is the speedo cable,the sound is coming below and back a bit from gear stick,sounds like it could be coming from area wear...

This sounds more like a u joint or internal transmission bearing to me. Normally if the speedo cable goes bad the speedo will not work. It could also be the gear that drives the cable too. I would have a trusted transmission expert look at it.
0helpful
1answer

Speedo not working in landcruiser. took out put in other toyota and it works fine. replaced speedo sensor in tranfercase thought that might be it still does not work. sensor has power to it. also i can...

No,the tone ring for your speedo sensor should be fixed and not move with your fingers.That is your problem.The tail houseing on your t-case will have to be removed and then you can find what broke.
1helpful
1answer

1fz-fe engine 80series using water unable to find leak small leak also runs rough especially at idle changed spark plugs and leads mechanic unable to find leak

you may have a blown head gasket ... water can get into a cylinder .. that would cause the rough running and the water goes out the exhaust .. thats why you cant find the leak .. often as the engine is running you will see bubbles in the radiator .. thats exhaust gas getting into the water jacket ... you may also see a little steam in the exhaust (white smoke) ..
0helpful
2answers

Fuel sender unit ohms on a 1991 80series landcrusier

Early FJs had a fuel sender with an ohm range of 2.1ohms when full, to 4.5 when half full, to 6.5ohms when empty. Some may range from 33-240 ohms. You should use a VOM (ohm-meter setting) to measure this resistance value at full, empty and half-full positions. Then you will know what gauge to purchase!!! Hope this helps, thanks for using Fixya.com to help solve your issue. Tater Todd
Not finding what you are looking for?

46 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...