How to remove left damper fork on 2000 Acura rl

SOURCE: cooling fan for acura tl 2000 does not work

If you can locate the temperature switch, looks like a large bolt head with 2 wires on it, bridge the wires on it, and this should make the fan work. If the fan works then this switch is faulty. If the fan doesn't then it could be the fuse, or a broken wire.
The fan switch is either on the radiator or on the thermostat housing.
If you can get to it easy, short across with a screwdriver.

SOURCE: 2000 Acura RL and 2000 Acura Integra GS ABS light on

The SRS computer needs to be reset, if you dont have a repair manual i would first suggest finding one for each car. The basic principal is that you jumper the diagnostic plug (under the glove box in the RL). The next step I believe is that you must depress the TCS button, then while holding it down you turn the key to on, continue to hold the TCS button for 15 sec and then let off. The check engine light should then blink really quick a few times and that means its reset. Im reciting this from memory so dont quote me on it. I have done it before for the RL but not the integra, id really suggest finding a repair manual though.

SOURCE: Trying to remove back seat in acura RL

THIS IS REAL SIMPLE I HAVE DONE THE SAME THING TO INSTALL THE IPOD INTERFACE MANY TIMES.. STEP 1 MOVE BOTH FRONT SEATS ALL THE WAY UP TO ALLOW U TO HAVE SPACE STEP 2 LOOK UNDER THE SEATS AT THE BASE AND U WILL SEE 2 BUTTON STYLE CLIPPS 1 ON EACH SIDE OF THE SEAT, PLACE YOUR FINGERS ON THE SIDE OF THE BUTTON AND PULL IT TOWARDS YOU,AND AT THE SAME TIME LIFT THE SEAT.. REPEAT THAT STEP FOR BOTH SIDES AND THE SEAT FLIPS RIGHT OUT

SOURCE: instaling a starter on a 2000 acura rl

Fairly hard. Tech time is around 4.5 hours

1. Raise the coolant reservoir, then remove the battery and battery base.
2. Remove the alternator belt and alternator.
3. Remove the left exhaust manifold cover.
4. Remove the left damper fork.
5. Disconnect the left suspension lower arm ball joint.
6. Remove the left driveshaft
1. Remove the transmission stop collar, then remove the exhaust pipe A.
2. Remove the front mount mounting bolts.
3. Attach the chain hoist to the engine.
4. Remove the left engine mount bracket.
5. Disconnect the starter cable and BLK/WHT wire, then remove the starter.

SOURCE: how do i remove the radion on a 200 acura rl

You cann't remove only radio you have to remove whole panel which contains radio.

There are two possible scenarios for you car radio panel


1. Your car can have Navigator, Climate Controller and Radio.

2. Your car can have Climate Controller and Radio.

You have to open whole panel.

This Panel contains some of SRS components, so have to be very careful while removing it!

Please search for "Acura RL Service Manual"

Follow this link you will be able to download it for free.

http://rapidshare.com/files/55768439/1996-2004__Acura3.5RL_Service_Manual.rar.html

PLEASE RATE!