SOURCE: transmission fluid
This transmission will use any transmission fluid that is at your local auto parts store. this town cars trans is universal when it comes to the fluid grade.
SOURCE: fill transmission fluid on 19999 audi a4
LISTEN CLOSE. THERE IS A PLUG ON PAN. REMOVE IT. WITH A SYRINGE TYPE CANISTER YOU NEED TO INJECT THE FLUID INTO IT UNTIL IT STARTS TO COME OUT. THEN CAREFULLY START VEHICLE AND INJECT ANOTHER 3/4 QUART UNLESS IT STARTS TO COME OUT OR EVEN A QUART.LET IT RUN FOR 5 MINUTES THEN CONTINUE TO INSERT UNTIL IT OVERFLOWS AND TIGHTEN THE PLUG BACK TO THE PAN. i WOULD ONLY USE AUDI VOLKSWAGON FLUID AND YES IT CAN RUN $14 TO $18 A LITER
SOURCE: Transmission fluid type and level
This is complicated.... Ok, your right, no dip stick is there! This is how it works.
Underneath the car, there is a plug (11mm) on the transmission case on the passenger side. It is about 3" up from the pan edge and on the front side of the case. With the engine running in PARK, remove this plug. If trans fuild doesn't run out of the hole, the level is low. Pour it in the hole on top (where the red cap is) until the fluid runs out - all while the car is running. Once it is roughly dribbling out, the trans is considered full. replace plug. Your done!!
Easy ehh? Dexron III fluid
SOURCE: how to replace our low beam headlight on 1999 town and country
1.) Open the hood of your van
2.) On the passenger side of the vehicle, look behind the headlight
enclosure. You will see a set of wires running into the back of it.
This is the power clip. Either with your hand or a flat-head
screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the
ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful
not to touch the glass part of the new bulb. The oils in your skin can
substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.
SOURCE: Front PCV Valve on chrysler town and country
PCV valve location-2.4L engine
PCV valve location-3.3L and 3.8L engines
922 views
Usually answered in minutes!
×