SOURCE: vehicle speed sensor
You will have to get to it probably from under the car it will be located just to the right of the driver's side axle
SOURCE: where is a knock sensor for 1998 Mercury Villager located?
Here is a image of it's location, I hope it helps.
SOURCE: ck engine light on code po335 p1336 also location of sensor?
P0335 and P0336 Engine crank sensor malfunction
To test this code, have a visual inspection of the location and wirings of the crank sensor. If the engine has a cam sensor, you might mistook it as the crank sensor (it is a good idea to contact ATS that can research this for you). Check the sensor wires for insulation making sure it is getting a voltage signal as shown in the wiring diagram. Sometimes, the wires itself is soaked with dirty oil causing the sensor to fail. If OK, check the engine timing belt system for any slack which can also cause the sensor to throw in the code. If all of these prove OK, remove the crank sensor and check it for resistance as compared to the standard specs. Lots of times, if the sensor probe end is contaminated with oil or cracked, this can only be revealed after the crank sensor is removed
SOURCE: Code reader knock sensor where is it located
According to the Haynes manual it is under the intake manifold, Upper and lower intake manifolds must be removed for access. If you go to Auto Zone, they have the sensor and can give you the step by step instructions to replacing the knock sensor with common tools. Good luck and hope this help.
SOURCE: where is a knock sensor for 2000 mercury villager
It is under the lower intake manifold in the valley of the engine.You must remove the cross over coolant tube to gain access to the knock sensor. It bolts into the cylinder head. Good luck
Testimonial: "good help, thanks."
164 views
Usually answered in minutes!
×