SOURCE: knocking when brakes applied
REAR BRAKE NOISE - SHOE AND LINING KIT
A shoe and lining kit is available for installation if an Elantra (XD) or Accent (LC)
equipped with rear drum brakes exhibits a chattering noise from the rear brakes when
the brakes are applied.
APPLICABLE VEHICLES:
• Accent (LC) and Elantra (XD) equipped with rear drum brakes and in the following
Production Date and VIN Range:
SERVICE PROCEDURE:
For further information, refer to the applicable Shop Manual.
Model Production Date Range VIN Range
ACCENT (LC) May 21,1999 - Dec. 28, 2005 ALL WITH DRUM
BRAKES.
ELANTRA(XD) June 30, 2000 - May 23, 2006 JOB#1-
KMHDN46016V363974
ACCENT SHOE & LINING
KIT
ASSEMBLY
58305-25A00 58305-25F00 7"(00MY - 05MY)
58305-25A10 58305-25F10 8"(00MY - 05MY)
SOURCE: replacing exterior door handle 2003 hyundai accent?
remove door panel which is attached by screws,peel away plastic liner and look inside door at back of door handle..using needle nose pliers pop off the small steel rods that are for inside door mechanism,then remove the one bolt that attaches the handle to the inside of door and from outside of door remove handle.Replace in reverse order!
SOURCE: How do I disassemble the [center]dash to replace
remove all the screws
there are 2 in center console at side 2 in ash tray and 2 others usually look arround pull gentley and locate all screws
SOURCE: Antifreeze for a 2003 Hyundai Accent
hi as this vehicle takes 6.5ltrs of liquid in the cooling system ( 1.6 16v based on ) as you did not give the engine size, but, 3.5ltrs of coolant is needed as it should be 50/50 depending on where you are and the temperature it has to deal with, warmer countries only need 30/70 That's 30 coolant to 70 water, but, if you are in a colder country it would be 80/20 that's 80 coolant to 20 water...and any standard coolant is ok no need for a specific one hope this helps please vote thanks
SOURCE: How to replace the third brake light (hatch) on a
Above the third brake light is a small panel, remove this panel using small screwdriver.
1. You'll see four (4) bolts, remove the three bolts that are painted black, do not remove the center bolt holding the plastic molding, this is for the door molding, and has nothing to do with the light.
2. Once those three bolts are out, you'll see two more small screws, remove them and you'll have access to the third brake light bulb.
Be careful when pulling out the bulb, my bulb broke, and I'm still trying to get pieces out! - Good luck.
490 views
Usually answered in minutes!
×