SOURCE: how to repair a fuel tank pressure sensor in a
The Fuel tank pressure sensor or Fuel pressure sensor? The pressure sensor for the fuel line is located in the Engine compartment, although I don't have the exact location it is located on the fuel line. If your talking about the Fuel level sensor that is actually part of the Fuel pump assembly. You should pick up the Haynes Repair manual on your vehicle before attempting either repair.
SOURCE: were is the fuel filter
IT IS INSIDE THE FUEL TANK . IT IS MADE INSIDE THE FUEL PUMP IT IS SERVIECABLE AND RECOMMENDED EVERY 30K . THERE IS A ACCESS TO THE TANK UNDER THE SEAT THERE IS A FEW SCREWS THAT HOLD IT A COVER DOWN REMOVE THIS AND YOU CAN ACCESS .
REOMOVE FUEL PUMP AND TAKE APART THE ACTUAL PUMP SEATS INSIDE THE FILTER .IF YOU TRY TO DO IT YOURSELT BE SURE NOT TO FORGET ANY O RINGS THEY TEND TO STAY IN THE OLD FILTER WHEN REPLACING AND IF YOU DONT SWAP OVER THE VEHICLE WILL NOT START
SOURCE: TPMS of KIA Rondo 2007
the only solution on that is to replace it. it is'nt be recalibrated. the instruction are in the operating manual that is sent with the car.
SOURCE: I have problem with my TPMS (KIA RONDO)2007 SENSORS
If you look in your manual, there is usually a procedure for resetting TPMS sensors. They can be as silly as turning off and on the headlights 3 times or honking the horn with the key turned to the on position. If you can't find it in there the dealer will have a tool to reset it for you.
SOURCE: 2007 kia rondo lx
You may have shorted the body module.
Testimonial: "thanks but where is the body module located on the kia ronda"
NOW TRY THIS great site!401 views
Usually answered in minutes!
×