Had the cam shaft sensor replaced on my 2003 Intrepid...clicking noise when attempting to start after a few attempts starts. Also, today the speedometer did not work and dash lights were losing power?

Anand Kumar

• 2035 Answers
• Posted on Jul 31, 2008

SOURCE: 2003 Dodge Intrepid 2.7L Car stalls and dies when hot

Please use this link to replace the thermostat on your car:

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528003fae2


Good luck...

SOURCE: Starter relay clicks, engine does not start

Your problem may be a ignition switch.  This part is inside the steering column.  Your ignition key/tumbler turns this piece to start the vehicle.  I see a lot of these that go bad.  Some are easy and some aren't.  Your Chilton should tell you how to change them.

Harvey N Tawatao

• 3854 Answers
• Posted on May 26, 2009

SOURCE: Won't run

There are to many things that can cause the no start. Here is a link that can help you understand the possible problems and links to how to retrieve the DTC codes which is activating your Auto Shutdown relay.
Good luck and hope this helps. Keep me posted http://www.allpar.com/fix/stall.html

SOURCE: 2005 Dodge Stratus ? Camshaft Position Sensor causing problems (I

I had the same problem with my '05 Stratus SXT 2.4 DOHC. I've replaced the cam pos sensor and it seems to be running fine right now. On the Dodge forums a lot of the guys say that you need to replace the crank pos sensor too. I've bought one of those just in case it comes back again. Hope this helps.

Ronny Bennett Sr.

• 6988 Answers
• Posted on Aug 20, 2010

SOURCE: 1999 dodge intrepid es 3.2L

Replace the coolant temp sensor to solve the problem.