SOURCE: 1999 nissan quest brake pad replacement
Remove wheel & tire,
remove 2 torx bolts that go from the inside to the outside of the vehicle. They are on the inner side of the brake caliper.
lift the caliper out of the rotor.
remove the brake pads.
To install, you must first squeeze the caliper piston back inot its bore. Do this slowly to prevent damage to the piston. You are forcing excess brake fluid back into the master cylinder reservoir. Slow constant pressure will get the job done. Use a large c clamp or a wooden hammer handel if that's all you have.
Fit the new brake pads in the calipers and slide the assembly back over the rotor.
install the 2 torx bolts, size 40? head I think.
You are done.
If rotors are scored bad, replace them too.
SOURCE: 1999 nissan quest
Rigoe the points for the timing belt are usually located on the sprokets in conection with marks or dots on the engine block some where around the sprockets that hold the timing belt. Remenber to bring the piston number one to TDC (top dead center), this means you have to locate the piston number one, take the spark plug out and turn the cranshaft (the one with the pulley) by hand until the piston is all the way up. On the distributor the rotor should point to the spark-plug wire number one (you can make a mark outside of the distributor cap where the number one spark-plug wire is pointing so when you take the cap off you can see if the rotor is pointing the same direction). With the timing belt cover off you are going to be able to aling all this points at the exact locacation all together. So we have: Piston number one at TDC, The rotor(enside the distributor cap) pointing to the number one spark-plug wire, and the mark of the sprockets pointing the marks of the engine block( litle dot or dash). If you get all this right you are have done a good job and ready to make a trip you can get all this just by turning the cranshaft by hand with a rachet and a big socket. God bless you.
SOURCE: 1999 Nissan Quest washer tank
Visit the site below for the needed parts:-
http://www.autozone.com/autozone/catalog/parts/partsLanding.jsp;jsessionid=A1http://www.autozone.com/autozone/catalog/parts/partsLanding.jsp;jsessionid=A1672379B5D3BFE00C4009668E08563C.diyprod2-b2c3?landingPage=parts&itemId=0-0672379B5D3BFE00C4009668E08563C.diyprod2-b2c3?landingPage=parts&itemId=0-0
Rate this solution.
SOURCE: I have a 1999 nissan quest and need to change the distributor.
This is late but may be useful for info purposes. The 1999 Nissan Quest carries a distributor and spark plug wires. Many owners complain having to go through numerous distributors. I went through 2 in one year with only 68K miles.
SOURCE: How to replace a thermostat
1999 Nissan/Datsun Truck Quest Mini Van 3.3L SFI 6cyl
The thermostat is located in the thermostat housing, which is mounted to
the coolant crossover tube. The bypass hose is connected to the
thermostat water inlet on one end, and to the intake manifold water
outlet on the other. The thermostat is
not
located in the intake manifold water outlet, where the upper radiator hose is connected.
Fig. Thermostat water inlet sealant application
Hope helps.
214 views
Usually answered in minutes!
×