No year, car, 2006 to 2010 XK jeeps.
no response to simple questions?
does the inside door button panel open the rear gate>
Yes/no... be like the first check,
the 2005+ jeep
all are user programmable.
if you read the operators guide
there is a feature here, for doors.
on mine, the doors can be set to only open drivers door. (for security)
takes special actions on the fob key to get all doors open if this is set.
I have mine turned off, but if on , takes, special button presses to get all doors open with fob.
its anti-car jack feature, my guess.
does the inside car controls work perfect
that be 1st, not fob.
×
Unlock all of the Jeep
Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
387 views
Usually answered in minutes!
×