How to change odometer reading from metric to miles on a 2005 Lincoln navigator?

There is no fuse for just the odometer, has main fuses for the whole instrument cluster . Odometer not working? instrument cluster problem. Have it checked by a professional repair shop.

Odometers
Each instrument panel cluster (IPC) is equipped with a season odometer and 2 trip odometers. The IPC uses the odometer rolling count message from the powertrain control module (PCM). The rolling count value is determined by counting the speed pulses from the vehicle speed signal (VSS). The IPC uses the rolling count data from the PCM and a software program to determine vehicle mileage. The odometers can be displayed in miles or kilometers. The units displayed is switched between English and metric by pressing the menu button on the driver information center (DIC) until the units mode is displayed. Pressing the set/reset button will select between English or Metric. . When the set/reset button is pressed to show the odometer in metric, km and the number will be displayed. When the odometer is in English, MI and the number will be displayed.


Season Odometer
The season odometer displays the total accumulated miles or kilometers of the vehicle. This value is permanently stored in the IPC. If an odometer malfunction occurs or if the IPC must be replaced, an authorized Delco service center must be contacted to program proper vehicle specifics, including mileage, for the IPC. The season odometer is capable of displaying 999,999 kilometers or 999,999 miles depending on units selected. Leading zeros are not displayed. The display will not roll-over to 000,000 if the maximum displayed miles or kilometers are reached. If the display limit is exceeded, the maximum value (999,999) is displayed. If the mileage is above 621,503 miles and metric units are selected the odometer shall display 999,999 km.


Circuit/System Testing
Ignition OFF, raise the vehicles drive wheels.
Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
? If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC.
Verify that the odometer is operating properly.
? If the odometer is not operating properly, replace the IPC.

Why?? anyway look in the handbook as some vehicles are easy to do and others can only be done at the dealers --encrypted software the curse of my life ,come back the old fashioned cars with a starting handle

check the battery terminals and posts are shiny clean and tight. Have a load test done on the battery to check for a cell bridge failure.

There is a e/m button on the dash by the mode and reset buttons that switches the odometer from english to metric or vise versa.

could part of the system be set for metric ?

Disconnect the battery for 90 seconds, then unplugged the cluster.. Then connect the battery with no cluster.. HVAC display changed to metric...

Re-connected the cluster again, display changes to imperial...

The cluster is what dictates what is displayed. It is metric by-default but a US imperial instrument cluster overrides that.

Did you accidentally push a button the dash to make the car read in metric? That would make sense if things were in kilometers instead of miles. Can't remember exactly how the 2005 model was but there should be buttons on the left side of the dash and one of those would change from miles to km. If your dash isn't like that, let me know and we can figure it out.

I have a 2004 CTS and thought my speedo was broke. It was reading very high and the odometer was wrong. My wife had accidently changed the reading to metric from english on the information center. Maybe your problem?

take it to a transmission shop and get it done. look in your yellow pages.

there is a button on the dash, it says ENGLISH/METRIC, push it.