SOURCE: 2003 Hyundai Elantra
NO. These models do not have warnings on the transmission failure. There is warnings only when the transmission encounters electrical component failure, overheating(some cars), low fluid. Usually the warning is the O/D flashing light, or a seperate transmission light. Hopefully this helps
SOURCE: 2003 Hyundai Elantra GLS. Check engine light, code PO133
Did you use a aftermarket O2 sensor or a genuine Hyundai one? If it's an aftermarket one it may be bad or not as good as the OEM one. See here for more details and other potential causes: P0133
SOURCE: need cylinder head torque specifications 2004
Install the cylinder head bolts. Starting at top center, tighten all
cylinder head bolts in sequence as shown in illustration, using the
Cylinder Head Bolt Wrench (09221 - 32001) or equivalent. Repeat the
procedure, re-tightening all cylinder head bolt to the specified torque.
(torque spec is Cold Engine 105-115 Nm (76-83 ft lb) )
. Install the timing belt tensioner pulley.
. Install the timing belt on the camshaft sprocket, making sure that
the tension side is tightened by turning the camshaft sprocket in
reverse, all timing marks are in alignment.
. Adjust the timing according to "Timing Belt"
. Install the rocker cover and tighten the bolts to the specified torque. Tightening torque: Rocker cover belt:
2.5-3.5 Nm (25-35 kg.cm, 2-3 ft. lbs.)
. Install the timing belt cover.
Install the new intake manifold gasket and the intake manifold. Tighten the nuts and bolts to the specified torque.
Install the new exhaust manifold gasket and the exhaust manifold.
Tighten the exhaust manifold attaching nuts to the specified torque.
. Install the surge tank and tighten the nuts bolts to the specified torque.
. Install the power steering oil pump and bracket.
. Install the ignition coil.
. Install the air intake hose.
Connect the vacuum hose, fuel hose and water hose.
. Install breather hose.
34 views
Usually answered in minutes!
×