SOURCE: 1999 volvo radio code
To reset the radio you have to leave the key in position one (the radio will come on, but the dash lights are not on) with the radio on for at least two hours. It can take up to four hours to reset.
Make sure the climate control and blower are in the off position to keep the battery from running down. Eventually the radio will say "code". There is a four digit code that is unique to each radio, if you don't have it you must contact the local Volvo dealer and have your VIN code. The VIN code is locate on the far top/right side of the dash, you must be outside the car to see it. It will begin with something like YV1LS...................
When you get this code from the dealer you input the code using the radio preset (1-6 buttons). If the radio says code again that means it is the incorrect radio code. Most likely the radio has been replaced. Then it would be alot easier to take it to the dealer since the radio has to be removed and the serial number taken off the radio chassis unit. Usually most dealers will do it for free if they think you'll come back for services, so just tell them you just bought it and be nice, hopefully it will work.
hope this helps
SOURCE: 99 Volvo S70 code 1618. What needs to be done to
CODE P1618 CABLE FAULT BETWEEN AW 50 Q2 TRANSMISSION CONTROL MODULE.AND MOTRONIC 4.4 ENGINE CONTROL MODULE LAMP LIGHTS.
SOURCE: how to turn off traction control in 99 s70 volvo that has automatic traction
On my 1998 S70 there is a rocker switch next to the sunroof and back window and mirror heat below the tachometer on the right hand side of the dashboard. If you have no other way, remove the fuse from traction control on the the main fuse box under the hood on the drivers side. There should be a guide to which fuse is which on the lid of the fuse box.
175 views
Usually answered in minutes!
×