The book calls for a 98-04 trans will fit I got a 03 to put in it the 98 has 4 wires coming out of it 2 red 1 blue 1black the 03 only has 3 wires 1 red 1 blue 1 black was wondering if they are linked together on inside and how do I hook it up
SOURCE: Parking lights on Nissan Frontier on - trailer
First check the fuses. There may be one for trailer running lights. Check also power at the harness. If the brake lights and turn signals are seperate, there has to be a converter from 5 to 4 wire. For the power to feed back to the brake lights it sounds like the vehicle wiring is direct and not using a converter... or one of the bulbs on the trailer is contacting both contacts. Try http://www.etrailer.com/faq-wiring.aspx and maybe get a simple 4 pin tester that plugs into the 4 pin connecter. Hope this helps.
SOURCE: i have a nissan moter
Ignore the white wire .No need to connect the white wire.white wire is not going to be used at all so I can shrink wrap the end of the wire?
The exhaust side plugs for emissions is a myth. Both plugs fire together to give two ignition sources which shortens the burn time and requires less ignition advance. Nissan's intent was that this set up will allow more EGR to be used to control emissions but luckily it also is good for mileage and efficiency.
The white wire? It's part of a system that can tell the distributor to revert back to single plug operation to reduce engine noise when passing or climbing a hill. A vacuum switch grounds the white wire and the distributor turns off the exhaust side plugs, but it also advances the timing to compensate for the longer burn time of a single plug. When power is reduced the switch opens and the distributor changes back to dual plug and retards the ignition.
---------------------
The Red (I) wire goes to the exhaust coil's negative terminal. The positive terminal goes to ignition switch power in the on position.
The Blue (E) wire goes to the intake coil's negative terminal. The positive terminal goes to ignition switch power in the on position.
The Black/White stripe wire goes to the ignition switch power in the on position.
--------
With power on the Black/White wire and engine turning over, will cause both the Red and the Blue wire to turn on and off to fire the coils.
--------
There are three wires coming from the distributor: Red, Blue and Black/White.
In operation and the ignition key is on, power flows through the Black/White wire and into the distributor to power it.
At the same time power from the ignition flows to the positive terminal of both coils.
When the engine is turning, the module inside the distributor applies and removes ground on the red and blue wires that go to the negative coil terminals and they fire.---
The coils have 12 volts on them at all times the ignition is on. The distributor's job is to make and break a ground connection on the other side of the coil to complete the circuit.
-------------
This will help.Thanks.Helpmech.
SOURCE: Need to know how many O2 wires in Nissan Maxima 03 sE
They have four wires, two for the signal and two for the heater circuit.
Testimonial: "That was very helpful, thank you."
Maybe the wiring diagram will help?
185 views
Usually answered in minutes!
×