Question about 2001 Honda Accord

Open Question

Replacing thermostat in 2001 honda accord

Got it out, need to put new thermostat back in

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
j_del

Jeremy Dellow

  • 1586 Answers

SOURCE: daughter lost car keys

Most likely you will need to do this, yes, and unfortunately it's pretty expensive.

Posted on Aug 27, 2008

Ad

Anonymous

  • 32 Answers

SOURCE: thermostat in honda accord LX 1992

The hose that goes from the radiator to the front of the motor. There are two bolts on the engne block. The thermostat is located in there.

Posted on Dec 20, 2008

Anonymous

  • 37 Answers

SOURCE: My 2001 Honda Accord will not start, do I need a new starter?

if you turn the key and engine fails to budge ,are you getting a clicking sound as if their is life from your startermotor ,if so maybe your solenoid is sticking which is part of your starter. give it a tap with a hammer .if it doesnt cure the problem than your starter is faulty. or even select nuetral on your transmission and try then.

Posted on Jan 29, 2009

valkierneth

  • 76 Answers

SOURCE: 2001 honda accord, air conditioner is not working,

one fan is for the a/c it will cycle on when the a/c is turned on the other fan should be linked to the temperature sensor. check your fuses if you haven't already. then check your temp sensor. i'm not sure on a honda but most newer cars have multiple sensors so you will have to find out which on is for the fan. also you need to find out if the fan is controled by a pcm as some new model cars have almost everything controled through the powertrain control module

Posted on Mar 07, 2009

Larry Cowan

  • 274 Answers

SOURCE: 2001 Honda accord trunk latch spring fell out

It probably goes on the outside of the casing One end arond the cable to hold the latch against the cable

Posted on Jul 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 ford explorer SOCH 4.0 ltr


Alway pick the thermostat with "fail-safe" relief. Look for a float like pressure relief port.

The low tech method to prevent trap air pocket is to drive the car onto an oil ramp (or hill) then fill coolant slowly.

Jan 11, 2014 | Cars & Trucks

2 Answers

I need to locate my thermostat and change it


follow top rad hose to motor under housing where hose connects put new one in the correct way spring goes to engine side

Aug 05, 2011 | 1992 Plymouth Voyager

1 Answer

I have a 2004 Ford Ranger @WD. The therostat is stuck open and needs to be replaced. I have been told by a Ford shop mechanic taht we willhave to replace the whole housing at a cost of $250+? Does that...


No its not. Drain the system a bit, remove the housing, remove the thermostat, put in the new one, replace the gasket, put the housing back, top up the system.


2004 ford ranger 3 0 thermostat replacement Google Search

The thermostat is 20 bucks! The housing and gasket is 12 bucks!

Ford Ranger Thermostat

Oct 01, 2017 | 2004 Ford Ranger

2 Answers

My 2002 Altima is overheating. The radiator hose is hot. I am losing antifreeze from the overflow resorvoir. Do I need to replace the thermostat?


Start with the Thermostat and if that doesn't correct the problem replace the water pump. An Easy test since it is getting into mid spring is to just remove the thermostat and see if that corrects the problem. If it does, get a new one and put it in and your done, if it doesn't get a water pump and put that in and put the thermostat back.

Apr 12, 2011 | 2002 Nissan Altima

1 Answer

I need to change the thermostat in my Taurus. Where is it located? Is it a difficult change?


if you find top hose follow it to engine -thermostat housing have to bolts most times /1)drain coolant 2)take about bolts pull up housing take out thermostat 3)put thermostat in (note;how thermostat is turned put new one same way) clean housing good 4)put gasket on with little bit of sealant tigthen bolts 5)put hose back on 6)fill up radiator with coolant &let run till warm up [check for leaks while warming up }top radiator off ;;;;;done

Nov 05, 2010 | 1998 Ford Taurus

3 Answers

How to replace themostat


It is located on the right side of the engine if you are looking under the hood. Follow the black radiator hose on the right all the way up to the engine and there is the thermostat housing. You will need a 10mm socket to remove three bolts and the housing and thermostat will come right off. Make sure when installing the new one that you have the spring side of the thermostat inside the engine. It will now work if installed backwards. The new thermo should come with a black o-ring or gasket-make sure to replace. This job takes about 30min.

Dec 04, 2009 | 1996 Ford Taurus

1 Answer

My montero keeps overheating. I put a new


These newer engines and air lock when changing the thermostat. Somewhere in the thermostat housing you should see some kind of a plug. You need to do this while engine is cool. Take the cap off the radiator. Remove the plug. You should get air out of the system. Keep letting air out as you put more coolant if needed. When all the air is gone put the plug back in and top off the radiator and you should be good to go.

Dec 02, 2009 | Mitsubishi Montero Sport Cars & Trucks

2 Answers

How to replace a thermostat on a 1987 olds delta 88


follow the radiator hose on the top of the radiator to where it goes into the top of the engine. remove the clamp connecting it to the engine. you will need to set a bucket under car if possible. you will loose about a 1/2 to 1 gallon of anti-freeze. there will be two screws holding on the nipple the hose was clamped to. remove those two bolts. your thermostat is now visible. when replacing be sure to get a gasket or it will leak.

Nov 12, 2009 | 1987 Oldsmobile Delta 88

1 Answer

Thermostat is overheating


This is one of the easiest things you will ever fix on your own car. Buy the new thermostat, and make sure you find out if ou need a O ring or a gasket. If it has a gasket you need to buy some blue sylicone also. Once you have all the parts then locate the termostat, special note make sure you notice how it went in. Remove it, after removeing the housing unit that its held inl. Sometimes they have to be screwed out of its housing. Once out and remembering how it looked inside the housing unit then put the new one back the same way. Now if its a O ring then put the new O ring in place of the old one. If its a gasket CLEAN the old one completely off then put your blue sylicone on both sides of the gasket, one side at a time not at the same time. then put the housing unit back together and tighten it back up.

You have just successfully changed your thermostat.

tepfy

May 03, 2009 | 1998 Isuzu Rodeo

1 Answer

Change termostat om Audi a4 1999 Q


follow the bottom hose on your radiator..follow it to the motor it will run into the thermostat and there will be three bolts remove them and there sits your thermostat take it out put the new one in put the new gasket on it then put your three bolts back in it,then put your hose back on and there you go..

Dec 04, 2008 | 2004 Audi A4

Not finding what you are looking for?
2001 Honda Accord Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...