SOURCE: gmc sierra turn flasher location
The flasher on this vehicle looks nothing like the flasher's of yesteryear. It will be located behind the drivers side knee bolster(under the steering wheel). It will be a small black box that is about 3 inches wide, 2 inches deep, and 1 inch thick. It may be somewhat difficult to locate because on some of the GM trucks they actually hide it behind the guage cluster bezel but to the left of the guages. Let me know if I can help you any further.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathan_3a3c556b4b17d1d2
SOURCE: 2003 GMC Sierra Pickup
You've checked all your signal bulbs are working? have you tried another signal relay?
SOURCE: low oil when engine warms up gmc sierra 1995
30-40 psi of oil pressure is fine for many vehicles including your GMC. I am assuming that the truck has more than 100,000 miles on it and still has the original engine in it. By rule of thumb you only need 10 psi per 1000 rpms in a typical street driven engine to give adequate oil pressure to keep the bearings from oil starvation. The oil pressure is typically higher when initial start up occurs because it is more viscous due to the temperature of the oil as the engines oil warms up the visconsity thins out and the oil flows more smoothly. The drop in oil pressure is a normal occurance. Above 45 is more than required for a daily driven street engine. I believe that the specs on that engine only list 30- 45 psi.
SOURCE: 1995 gmc sierra 4x4 shifter wont go in 4 wheel drive.
my name is michael. You said it will go into 4 low but not into 4 hi. Have you lifted the truck to see if it is operational? Does your 4x4 light come on? Does it grind into either 4 hi or low? And one thing, has anyone ever taken the axle out on the right hand side? Please feel free to email me at [email protected].
To find the FLASHER on 1994 GMC Truck C1500 1/2ton Sub 2WD 5.7L TBI 8cyl. the Flasher is located:
Front seating area, driver side, under dash, driver side of steering column, mounted in relay bracket
Application: Hazard flasher
Turn SIgnal flasher is one independent unit.
Hope helps-
165 views
Usually answered in minutes!
But is it bolted in or a clip?
×