SOURCE: 1990 Oldsmobile Cierra camshaft pully
do you mean crankshaft pulley? i dont know of a cam pulley on these.
if so replace the whole thing. the rubber on these go bad and rip away from the pulley. it happens. Just get a new one. should be a press fit one. may need a pulley puller. not the JAW type, but the 3 bolt type.
goold luck
Michael
ASE certified
plz rate
SOURCE: I need the firing order for a 1996 olds cutless
Your order is 1-2-3-4-5-6
Coil packs:
5/2 3/6 4/1
Cylinders:
1 3 5
2 4 6
Hope this helps,
matt
SOURCE: how do you replace aheadlight light bulb ina olds
Remove plastic Grill (6 screws)
Remove Turn Signal Light (3 Screws)
This allows you to access the 4 screws that hold in the Headlight. Remove these and then remove the headlight. Once out, then just turn the bulb and remove. Be careful with the plastic clip that holds the bulb to the wiring harness. Since the car is old, the plastic will easily break.
SOURCE: trying to find the lock up converter on my 1991
It is the torque converter. It is located between the engine flexplate and the transmission front seal in the bell housing. I believe what you are looking for is the torque converter lockup solenoid. it is behind the side transmission cover on the left.
Testimonial: "thanks"
SOURCE: looking for codes for 92 cutless cierra the codes
Hi,
I have a 2005 pt cruiser and i ran out of gas and got towed to get gas and after filling up i went to turn the car on and it wont start. It makes no noise and wont even turn over. The battery is brand new and all the lights and everything turn on. A red light blinks..not sure what that means or if that always blinks.. does anyone know the problem or how to fix it?
56 views
Usually answered in minutes!
×