My Toyota duet can't start and only cranks. Spark plugs OK, coil OK, fuel pump OK. What could be the problem?

hI, IT COULD BE ONE OF THE IGNITION COILS AS THEY ARE IGNITION AMPLIFIER'S TO BOOST THE SPARK.

did you get the plug wires on correctly. check any electrical connections you may have undone. check for codes. it may be coincidental that you lost spark and a sensor may have gone bad.

Ok then.

Yes it is very much possible.But there are many other possibilities too,including starter and spark plugs issue.

If your engine cranks normally but will not start because it has no spark, or it stalls and won't restart because it has no spark.

You can also do a test to confirm the problem .The procedure to do the test is as follows:---

If your engine has spark plug wires, disconnect one of the plug wires from a spark plug and place the end of the wire near a metal surface on the engine. Then insert a small Phillips screwdriver into the end of the wire (the plug boot), or a small bolt or nail to provide a conductive path. Then crank the engine and look for a spark to jump from the screwdriver, bolt or nail in the end of the plug wire to the engine. If you do not see a spark, there is an ignition problem.

OR-----------

If your engine has a coil-on-plug ignition system with no plug wires, In that case remove one of the coils from the spark plug and insert an old spark plug, a spark plug tester or a screwdriver into the end of the coil. Ground the spark plug or plug tester to the engine, then crank the engine and look for a spark. No spark indicates an ignition problem.If the engine has no spark, check for voltage at the coil positive terminal when the ignition key is on. If NO voltage, then problem is on the trigger side of the coil (pickup, crank sensor, ignition module or primary wiring circuit).

But If there is NO voltage at the coil itself, then in that case the problem is on the supply side (the ignition switch or ignition wiring circuit).-----------------

Jeep cranks but no start:----------------

A jeep that cranks over but doesn't start, in many cases will be due to a bad fuel pump, a broken timing belt, an inoperative cam sensor or crank sensor. Also these problems are related to faulty spark plug. Check the spark at spark plugs when you start the jeep. Do you notice any spark. Actually you should see. If in case there is no spark then it's a spark plug problem. Also the coil pack gives power to spark plug. So check the voltage at coil pack. It will show 12 volt. If there is no voltage noticed at coil pack then its faulty coil pack that has to be replaced. If all the possible options checked out ok then check the car starter. The starter gets power from battery to start the jeep. If the starter is faulty then it will not let the car to start. Also check and confirm that there is fuel in the jeep. If its very low fuel then in some cases this causes the problem. Also check and confirm that fuel pump is functioning properly and the fuel filter is not clogged. One of the easiest ways to check for a fuel pump related problem is to spray a little starting fluid into the air intake while trying to start the jeep. If the car starts momentarily, then there's a good chance the fuel pump is not working or the jeep is out of gas. You can also listen for the fuel pump's humming sound when the key is first turned on. Also if a inoperative fuel pump is suspected, a good technician will always check to verify there is power and ground being supplied to the pump, to eliminate the possibility of a bad relay or electrical issue. Fuel pressure can be checked with a pressure gauge and if there is pressure, pulse can be checked at the fuel injectors in several ways including the most common, with the use of noid lights. If the injectors don't have pulse the engine won't start. ---------- This troubleshooting tips will help you to solve the problem. Thanks. Helpmech.

is the your car engine cranking when you try to start, first check spark plugs ignition coils, remove one ignition coil and spark plug fix the spark plug in to the ignition coil then connect ignition coil to wiring and keep spark plug body touching on ground of engine head mettle parts, ask some one to crank engine then you can see is the plug sparking or not, do the same way to all the coils and plug otherwise you have to buy a ignition spark tester, is the all the coils and spark plugs are OK then check the fuel pump, it's sitting in under rear seat, before that do one thing disconnect oxygen (O2) sensor wiring and crank engine, the thing is if your oxygen sensor completely dead fuel pump will stop working, if engine start after disconnect O2 sensor, replace new O2 sensor, otherwise need to check fuel pump relay fuse and fuel pump. is this information helped you? please vote me and give a comment.

Most probably its a low fuel pressure related problem.Get the fuel pressure checked.If its low then this is faulty fuel pump and clogged fuel filter issue.the other possibilities are,-----

A car that cranks over but doesn't start, in many cases will be due to a bad fuel pump, a broken timing belt, an inoperative cam sensor or crank sensor. Also this problems are related to faulty spark plug. Check the spark at spark plugs when you start the car. Do you notice any spark. Actually you should see. If in case there is no spark then it's a spark plug problem. Also the coil pack gives power to spark plug. So check the voltage at coil pack. It will show 12 volt.If there is no voltage noticed at coil pack then its faulty coil pack that has to be replaced.If all the possible options checked out ok then check the car starter. The starter gets power from battery to start the care. If the starter is faulty then it will not let the car to start. Also check and confirm that there is fuel in the car. If it very low fuel then in some cases this causes the problem. Also check and confirm that fuel pump is functioning properly and the fuel filter is not clogged. One of the easiest ways to check for a fuel pump related problem is to spray a little starting fluid into the air intake while trying to start the car. If the car starts momentarily, then there's a good chance the fuel pump is not working or the car is out of gas. You can also listen for the fuel pump's humming sound when the key is first turned on. Also if a inoperative fuel pump is suspected, a good technician will always check to verify there is power and ground being supplied to the pump, to eliminate the possibility of a bad relay or electrical issue. Fuel pressure can be checked with a pressure gage and if there is pressure, pulse can be checked at the fuel injectors in several ways including the most common, with the use of noid lights. If the injectors don't have pulse the engine won't start. ---------- This troubleshooting tips will help you to solve the problem.Thanks.Helpmech.

So your telling me that this car is a stick and you can't pop the clutch to start it ? Correct?
I'm gonna give you a list of thing to check, good luck.

a)Do you have crank no start? (see entire write up)
b)No crank no start?, ( battery, battery cables, ignition switch,,starter relay)
c)No dash lights, no crank? (battery, battery cables ignition switch)
If you have symptom A then the affected items are , ignition switch, battery, battery cables, starter, starter relay ,coil, coil pack, ignition module ,Distributor cap ,rotor, (if applicable) spark plugs and wires.
The best thing to do is to first make sure your timing belt didn't break. As long as the engine cranks you can do this. Give the battery a 3 min charge . Then have a helper crank the vehicle while you observe the rotation of all the pulley's and belts. They must rotate together. If the vehicle has a distributor remove the cap ground the coil wire and watch the rotor as the engine is cranked. it should spin. If this is a-ok your worse nightmare is over.
Now we have eliminated the timing belt as being a cause. We now have to charged the battery again for three min and load test it( this is best done by a repair shop a load tester is expensive .If the battery if more than 5yrs old you may want to replace it.
If battery does not pass load test replace it.
Whatever you decide the rest of the items can NOT be checked out without a fully charged battery.
Check ignition switch and starter relay for B+ going to them and leaving them. Check starter circuit. Make sure B+ is making it to starter ( use a digital voltmeter). If B+ (12 volts) is making it to the starter and it doesn't crank then the starter is defective. Do a starter current draw test to verify this or remove the starter and have it bench tested.
If starter cranks now your into coil testing .
Pull a spark plug hook it up to a spark tester and ground it, now crank the engine if you get spark coil is ok and in all likelihood so is module.
If you don't get spark test for spark at the coil wire.
If you get spark here and don't get it at the spark plug wire problem is at distributor cap , rotor or spark plug wire. If plugs look bad use a fresh plug to do testing and naturally replace them.
If all of the above are a-ok.
Next is fuel checks.
Easiest fuel check is to put key into ignition cylinder and turn to on position. Lister for pump to buzz or hum. if it doesn't then check fuel pump relay for B+ going to it and leaving it and going to the pump. If B+ making it to pump and it doesn't turn on the pump is your problem. If B+ not making it to pump either the relay or the ignition switch is defective.
Naturally if the pump is defective have a repair shop do the repair . Its dangerous and a real pain.
Good Luck
IN YOUR CASE I BELIEVE YOU NEED A NEW BATTERY UNLESS THIS ONE IS FAIRLY NEW.

A car that cranks over but doesn't start, in many cases will be due to a bad fuel pump, a broken timing belt, an inoperative cam sensor or crank sensor. Also these problems are related to faulty spark plug. Check the spark at spark plugs when you start the car. Do you notice any spark. Actually you should see. If in case there is no spark then it's a spark plug problem. Also the coil pack gives power to spark plug. So check the voltage at coil pack. It will show 12 volt. If there is no voltage noticed at coil pack then its faulty coil pack that has to be replaced. If all the possible options checked out ok then check the car starter. The starter gets power from battery to start the car. If the starter is faulty then it will not let the car to start. Also check and confirm that there is fuel in the car. If its very low fuel then in some cases this causes the problem. Also check and confirm that fuel pump is functioning properly and the fuel filter is not clogged. One of the easiest ways to check for a fuel pump related problem is to spray a little starting fluid into the air intake while trying to start the car. If the car starts momentarily, then there's a good chance the fuel pump is not working or the car is out of gas. You can also listen for the fuel pump's humming sound when the key is first turned on. Also if a inoperative fuel pump is suspected, a good technician will always check to verify there is power and ground being supplied to the pump, to eliminate the possibility of a bad relay or electrical issue. Fuel pressure can be checked with a pressure gauge and if there is pressure, pulse can be checked at the fuel injectors in several ways including the most common, with the use of noid lights. If the injectors don't have pulse the engine won't start. ---------- This troubleshooting tips will help you to solve the problem. Thanks. Helpmech.

this maybe caused by no fuel or faulty fuel pump, ignition coil, wire and plug crank position sensor. first check for spark by removing on spark plug wire and put a spark plug in the spark plug wire boot, donot touch the plug only the boot have someone crank the car over. if you see spark, that part of the ignition is good. if not, check the coil resistance if should 40 to 80 ohm with a volt meter pf not replace. if ok, but no spark check the igniton control madule make sure the coil and module are receiving current. if not check the fuse that feels them. if it is ok, check distributor cap and rotor. if rotor and cap are fine, check for fuel at either the fuel filter, the fuel return line or removing some spark plug and see if they are wet. if there is no fuel check the fuel pump and the fuse and relay that control the pump. if there is fuel with high pressure but there is no spark, check the crank sensor for signal with a volt meter while cranking the vehicle

if you believe some one put water or bad gas in your tank, then you will have to drain the tank. however, to know if you have water in your gas, first disconnect fuel return line or the line that goes in to the fuel pressure regulator put some fuel in a clear glass and let it sit for 15min.if you see white cloud at the bottom of the glass or water. drain the tank. if not check for spark by removing one spark plug wire and spark plug. place the spark plug in the spark plug wire boot and touch it on the metal part of the car. do not touch the spark plug itself only the booth with the plug in the boot. have some one crank the car over. if you see spark, the spark part is ok. but if no spark, check the coil with a volt meter it should be 3 to 8 ohm if not replace the coil. if ok, check for fuel by removing one spark plug or two and see if they are wet,if wet pump is ok. if not check the fuel pump relay and fuse. if fuse is blown replace. check relay with a volt meter. resistance of the relay should be between 40 to 80 ohm. not mega ohm,if mega ohm, replace. if not , listen to the fuel pump while some one is cranking the car. if you donot hear the pump, disconnect the pump electrical connector and applive 12 volt and ground to the pump by using a jumper or any wire and listen for pump sound. if not replace the pump. if there is sound coming from the pump, it is ok. check the fuel pressure regulator with a fuel pressure gauge or simply disconnect the vaccum from the regulator and try starting the car. if fuel pump is ok and spark is ok. then it maybe the computer or the crank position signal. also check the fuel filter it may be clog.