2005 Nissan Frontier Logo

Related Topics:

j
jose Posted on Dec 04, 2016

05 nissan frontier 4.0 locate oil pressure sender

5 Related Answers

dennymulford

Dennis Mulford

  • 1055 Answers
  • Posted on Jan 28, 2009

SOURCE: oil pressure needle at H

sounds like an oil pressure sening unit un plug it whilf its running and see if the gauge goes too zero,if not then the prob is the gauge, the sending unit is only about 15.00 at auto zone and easy too put in

Ad

Anonymous

  • 5 Answers
  • Posted on May 06, 2009

SOURCE: Nissan 2007 Frontier tire pressure monitoring system

check all the tire pressures first.... then drive it for the next 10-15 miles to reset it.... it worked in my frontier ... I had the same problem as well


Hope that helped

Nissan tech +6 years

Anonymous

  • 484 Answers
  • Posted on Sep 14, 2009

SOURCE: 2006 Nissan frontier 4 cylinder belt diagram + tensioner pulley

They are under the hood or on the front crossmember.

Regards,
matt

leedavidian

Auto Repair Help

  • 1420 Answers
  • Posted on Feb 11, 2011

SOURCE: where is the oil pressure

Welcome to FixYa.com Thank you for Using FixYa.com Kind Regards, Lee Your FixYa Expert and Master Technician leedavidian_180.png

Anonymous

  • 1 Answer
  • Posted on Feb 15, 2012

SOURCE: Nissan 2007 Frontier tire pressure monitoring system

There should be a way to reset any car alarm. If the problem persist the alarm will come back on. Most alarms probably have more to do with the sensor system than actual problems. Of course that means you have to pay the dealer to "fix" a problem you don't have. Exasperating! They should pass a law that allows a car owner to reset his alarm system.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Having a few issues with my 2006 Nissan Frontier. First, The oil pressure gauge is acting screwy. While driving long distances it has started to flucate and when at idle it often drops down? Next, have a...

had these same indications on a v8 range rover from new. Turned out to be a rotating main bearing shell opening the oil hole to the crank (low pressure) then closing off the hole ( high pressure). I would be having a mechanical oil gauge fitted ( service mechanic ) to eliminate any bearing fault. I would also be replacing the oil pressure sender unit. as a precaution
0helpful
1answer

Transmission fluid dipstick?

Go to this LINK to see location, the truck is a 05 but the location is the same on your truck.
0helpful
2answers
0helpful
1answer

Oil leak appears to be oil sending unit where is it located

Replace faulty oil pressure sender.
Oil pressure sender is usually on the engine block, screwed into a fitting accessing the motor oil distribution gallery.

7helpful
1answer

Where is the oil pressure sending unit located on a 2000 jeep grand cherokee 4.0 liter

Removal & Installation
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
6eaedba.gif
Oil pressure sending unit


To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.
1helpful
2answers

What is eng oil capacity for a nissan frontier 4 banger 2000 model

Including filter; the oil capacity for a 2WD, 2000, Nissan, Frontier, 4cyl (Ka24de) is 3-3/4 quarts. Straight out of the Haynes manual.
3helpful
1answer

Where is the oil sending unit switch located on a 2003 4.0L jeep grand cherokee?


Removal & Installation

  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
7f7455b.jpg
To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.
1helpful
1answer

Nissan 2007 Frontier tire pressure monitoring system

check all the tire pressures first.... then drive it for the next 10-15 miles to reset it.... it worked in my frontier ... I had the same problem as well


Hope that helped

Nissan tech +6 years
Not finding what you are looking for?

594 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...